Search results
Results from the WOW.Com Content Network
The rule affected only those aircraft operating under IFR when in level flight above 3,000 ft above mean sea level, or above the appropriate transition altitude, whichever is the higher, and when below FL195 (19,500 ft above the 1013.2 hPa datum in the UK, or with the altimeter set according to the system published by the competent authority in ...
The one-engine inoperative (OEI) service ceiling of a twin-engine, fixed-wing aircraft is the density altitude at which flying in a clean configuration, at the best rate of climb airspeed for that altitude with one engine producing maximum continuous power and the other engine shut down (and if it has a propeller, the propeller is feathered ...
In Australia, Visual Navigation Charts (VNCs) and Visual Terminal Charts (VTCs) usually indicate MEF information by use of bold elevation figures for each grid. Pilots are also required to ensure their planned route does not contravene the minimum flying altitude regulations contained in CAR 167. This restriction is normally 1000FT above ...
The aircraft Mach number at which these effects appear is known as its critical Mach number, or M CRIT. The true airspeed corresponding to the critical Mach number generally decreases with altitude. The flight envelope is a plot of various curves representing the limits of the aircraft's true airspeed and altitude. Generally, the top-left ...
This maximum altitude is known as the service ceiling (top limit line in the diagram), and is often quoted for aircraft performance. The area where the altitude for a given speed can no longer be increased at level flight is known as zero rate of climb and is caused by the lift of the aircraft getting smaller at higher altitudes, until it no ...
In aviation, atmospheric sciences and broadcasting, a height above ground level (AGL [1] or HAGL) is a height measured with respect to the underlying ground surface.This is as opposed to height above mean sea level (AMSL or HAMSL), height above ellipsoid (HAE, as reported by a GPS receiver), or height above average terrain (AAT or HAAT, in broadcast engineering).
A clearance always specifies a clearance limit, which is the farthest the aircraft can fly without a new clearance. In addition, a clearance typically provides a heading or route to follow, altitude, and communication parameters, such as frequencies and transponder codes. In uncontrolled airspace, ATC clearances are unavailable.
For jet aircraft operating in the stratosphere (altitude approximately between 11 and 20 km), the speed of sound is approximately constant, hence flying at a fixed angle of attack and constant Mach number requires the aircraft to climb (as weight decreases due to fuel burn), without changing the value of the local speed of sound.