Search results
Results from the WOW.Com Content Network
In the electrical wiring of buildings, a cable tray system is used to support insulated electrical cables used for power distribution, control, and communication. Cable trays are used as an alternative to open wiring or electrical conduit systems, and are commonly used for cable management in commercial and industrial construction.
A TV tray table, TV dinner tray, TV table, or personal table is a type of collapsible furniture that functions as a small and easily portable, folding table. These small tables were originally designed to be a surface from which one could eat a meal while watching television. The phrase tray-table can also refer to a fold-away tray, such as ...
The TV tray table is typically a small table, which may have legs that fold to allow it to be carried like a tray. The airplane tray table is a tray built into the back of an airline seat , which folds down so that the person sitting in the seat behind the one containing the table can use it as a surface from which to eat meals served on the ...
A 240/120 V split-phase service drop providing power to a residence in USA. The three wires from the utility pole enter through a weatherhead (top) into a vertical conduit, which routes them to the electric meter (bottom).
A power cable is an electrical cable, an assembly of one or more electrical conductors, usually held together with an overall sheath. The assembly is used for transmission of electrical power . Power cables may be installed as permanent wiring within buildings, buried in the ground, run overhead, or exposed.
A single-wire transmission line (or single wire method) is a method of transmitting electrical power or signals using only a single electrical conductor. This is in contrast to the usual use of a pair of wires providing a complete circuit, or an electrical cable likewise containing (at least) two conductors for that purpose.
A cable for Ethernet may be wired to either the T568A or T568B termination standard at both ends of the cable. Since these standards differ only in that they swap the positions of pairs 2 and 3 – the only pairs used by the formerly common 10BASE-T and 100BASE-TX – a cable with T568A wiring at one end and T568B at the other functions as a ...
A crossover cable may also be used to connect two hubs or two switches on their upstream ports. Because the only difference between the T568A and T568B pin and pair assignments are that pairs 2 and 3 are swapped, a crossover cable may be envisioned as a cable with one modular connector following T568A and the other T568B (see TIA/EIA-568 wiring ...