enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. String trimmer - Wikipedia

   en.wikipedia.org/wiki/String_trimmer

   A string trimmer, also known by the portmanteau strimmer and the trademarks Weedwacker, Weed Eater and Whipper Snipper, [1] [a] is a garden power tool for cutting grass, small weeds, and groundcover. It uses a whirling monofilament line instead of a blade, which protrudes from a rotating spindle at the end of a long shaft topped by a gasoline ...

3. Craftsman (tools) - Wikipedia

   en.wikipedia.org/wiki/Craftsman_(tools)

   Craftsman is a line of tools, lawn and garden equipment, and work wear.Originally a house brand established by Sears, the brand is now owned by Stanley Black & Decker.. As with all Sears products, Craftsman tools were not manufactured by Sears during the company's ownership, but made under contract by various other companies.

4. Timing mark - Wikipedia

   en.wikipedia.org/wiki/Timing_mark

   A timing mark is an indicator used for setting the timing of the ignition system of an engine, typically found on the crankshaft pulley (as pictured) or the flywheel. [1] These have the largest radius rotating at crankshaft speed and therefore are the place where marks at one degree intervals will be farthest apart.

5. Flywheel - Wikipedia

   en.wikipedia.org/wiki/Flywheel

   A flywheel with variable inertia, conceived by Leonardo da Vinci. The principle of the flywheel is found in the Neolithic spindle and the potter's wheel, as well as circular sharpening stones in antiquity. [3] In the early 11th century, Ibn Bassal pioneered the use of flywheel in noria and saqiyah. [4]

6. Flywheel energy storage - Wikipedia

   en.wikipedia.org/wiki/Flywheel_energy_storage

   NASA G2 flywheel. Flywheel energy storage (FES) works by accelerating a rotor to a very high speed and maintaining the energy in the system as rotational energy.When energy is extracted from the system, the flywheel's rotational speed is reduced as a consequence of the principle of conservation of energy; adding energy to the system correspondingly results in an increase in the speed of the ...

7. Tap and die - Wikipedia

   en.wikipedia.org/wiki/Tap_and_die

   Improper or zero float for use with screw machines (recommended feed .1 slower to establish float for 40 tpi or higher and .15 slower for 40 tpi or finer [4]) Improper spindle speed. To overcome these problems, special tool holders are required to minimize the chances of tap breakage during tapping.