Search results
Results from the WOW.Com Content Network
The Whisper family was developed as a line of accurate, multi-purpose cartridges using relatively heavy rifle bullets for a given caliber in subsonic loads. [1] [2] [3] The intention was to create an extremely accurate cartridge family for military, police, competition and specialized hunting markets that could also be easily sound suppressed.
Subsonic ammunition is ammunition designed to operate at velocities below the speed of sound (Mach 1), which at standard conditions is 340.29 m/s (1,116.4 ft/s). This avoids the supersonic shockwave or "crack" of a supersonic bullet, which, particularly for suppressed firearms, influences the loudness of the shot.
Components of a modern bottleneck rifle cartridge. Top-to-bottom: Copper-jacketed bullet, smokeless powder granules, rimless brass case, Boxer primer.. Handloading, or reloading, is the practice of making firearm cartridges by manually assembling the individual components (metallic/polymer case, primer, propellant and projectile), rather than purchasing mass-assembled, factory-loaded ...
The DSR-1 Subsonic is a variant optimized for 7.62×51mm NATO/.308 Winchester subsonic ammunition usage. The barrel length is reduced to 310 mm. The barrel length is reduced to 310 mm. The 8 inch twist rate of the barrel is especially adapted to stabilize the long heavy projectiles used in subsonic ammunition.
The .300 Whisper (7.82×34mm) is a CIP standard [1] cartridge in the Whisper family, a group of cartridges developed in the early 1990s by J.D. Jones of SSK Industries.It was developed as a multi-purpose cartridge, capable of utilizing relatively lightweight bullets at supersonic velocities as well as heavier bullets (200–250 grains) at subsonic velocities.
7.62mm Thumper is a barrel specification optimized to run larger bullets out of standard 7.62×39mm cases. [1] Barrels are cut to a standard 7.62×39mm "Russian" chamber but the bore ideally uses a faster 1:8" rifling twist rate in order to stabilize bullets heavier than 200gr at subsonic speeds. [2]
The Best Tools and Products to Clean Brass. It seems almost every brass owner has a homemade solution they swear by, from ketchup to plain water and dish soap.
To manufacture cases for cartridges, a sheet of brass is punched into disks. These disks go through a series of drawing dies. The disks are annealed and washed before moving to the next series of dies. The brass needs to be annealed to remove the work-hardening in the material and make the brass malleable again ready for the next series of dies ...