Search results
Results from the WOW.Com Content Network
A reciprocating saw is a type of handheld, small, machine-powered saw, in which the cutting action is achieved through a push-and-pull ("reciprocating") or back-and-forth motion of the blade. The original trade name, Sawzall, is often used in the United States, where Milwaukee Electric Tool first produced a tool of this type in 1951. [1] [2]
An oscillating multi-tool or oscillating saw is a multitool and power tool that oscillates (rather than rotating or reciprocating), powered by battery or mains. The name "multi-tool" is a reference to the many functions that this tool can perform with the range of attachments available.
It is found in a wide range of mechanisms, including reciprocating engines and pumps. The two opposite motions that comprise a single reciprocation cycle are called strokes. [citation needed] A crank can be used to convert into reciprocating motion, or conversely turn reciprocating motion into circular motion. [citation needed] [1]
Radial Arm Saw. A radial arm saw is a cutting machine consisting of a circular saw mounted on a sliding horizontal arm. Invented by Raymond DeWalt in 1922, the radial arm saw was the primary tool used for cutting long pieces of stock to length until the introduction of the power miter saw in the 1970s.
Ancient Egyptians had manual drills resembling a crank at the time ... The 15th century also saw the introduction of cranked rack-and ... 10.3764/aja.107.1.1, ...
A hand-held circular saw is the most conventional circular saw. This miter saw is a circular saw mounted to swing to crosscut wood at an angle. A table saw. Tractor-driven circular saw. A circular saw or a buzz saw, is a power-saw using a toothed or abrasive disc or blade to cut different materials using a rotary motion spinning around an arbor.
A connecting rod, also called a 'con rod', [1] [2] [3] is the part of a piston engine which connects the piston to the crankshaft. Together with the crank, the connecting rod converts the reciprocating motion of the piston into the rotation of the crankshaft. [4] The connecting rod is required to transmit the compressive and tensile forces from ...
A crosshead as part of a reciprocating piston and slider-crank linkage mechanism. Cylindrical trunk guide Hudswell Clarke Nunlow; crosshead and two slide bars. In mechanical engineering, a crosshead [1] is a mechanical joint used as part of the slider-crank linkages of long stroke reciprocating engines (either internal combustion or steam) and reciprocating compressors [2] to eliminate ...