Search results
Results from the WOW.Com Content Network
ISO Standards Handbook – Technical drawings, a broad collection of all basic ISO drawing standards Vol.1 Technical drawings in general, ISBN 92-67-10370-9; Vol.2 Mechanical engineering drawings, construction drawings, drawing equipment, ISBN 92-67-10371-7; ISO 128 Technical drawings—General principles of presentation
1. Center line, the central axis of a feature. 2. Class, for example, "paint per spec XYZ revision C type 1 class 2" may be abbreviated as "paint per spec XYZ REV C TY 1 CL 2" or even in some cases "paint per spec XYZ-C-1-2". (The latter practice is not uncommon but is cryptic for workers with minimal training and experience. The first two ...
The revolving magnetic field produced with a two-phase system allowed electric motors to provide torque from zero motor speed, which was not possible with a single-phase induction motor (without an additional starting means). Induction motors designed for two-phase operation use a similar winding configuration as capacitor start single-phase ...
A drawing meant to depict the physical arrangement of the wires and the components they connect is called artwork or layout, physical design, or wiring diagram. Circuit diagrams are used for the design ( circuit design ), construction (such as PCB layout), and maintenance of electrical and electronic equipment.
1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45) A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35. Connectors on this cable would be designated ...
The process of producing engineering drawings is often referred to as technical drawing or drafting (draughting). [1] Drawings typically contain multiple views of a component, although additional scratch views may be added of details for further explanation. Only the information that is a requirement is typically specified.
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
A typical one-line diagram with annotated power flows. Red boxes represent circuit breakers, grey lines represent three-phase bus and interconnecting conductors, the orange circle represents an electric generator, the green spiral is an inductor, and the three overlapping blue circles represent a double-wound transformer with a tertiary winding.