enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Expansion joint - Wikipedia

   en.wikipedia.org/wiki/Expansion_joint

   An expansion joint is designed to allow deflection in the axial (compressive), lateral (shear), or angular (bending) deflections. Expansion joints can be non-metallic or metallic (often called bellows type). Non-metallic can be a single ply of rubberized material or a composite made of multiple layers of heat and erosion resistant flexible ...

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   EJMA: Expansion Joint Manufacturers Association; CGA: Compressed Gas Association; PCA: Plumbing Code of Australia; Pipes must conform to the dimensional requirements of: ASME B36.10M: Welded and seamless wrought-steel pipe; ASME B36.19M: Stainless-steel pipe; ASME B31.3 2008: Process piping; ASME B31.4 XXXX: Power piping

4. Expansion Joint Manufacturers Association - Wikipedia

   en.wikipedia.org/wiki/Expansion_Joint...

   The standards are a combination of a variety of expansion joint manufacturers' knowledge and experience. [2] [3] The EJMA organization performs extensive technical research on a variety of topics concerning the design and manufacturing of expansion joints. [4] This knowledge contributes to providing new versions of the EJMA book of standards.

5. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

6. Plastic pipework - Wikipedia

   en.wikipedia.org/wiki/Plastic_pipework

   Plastic Pipe lengths manufactured in Australia by extruding HDPE material.. Plastic pipe is a tubular section, or hollow cylinder, made of plastic.It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow—liquids and gases (fluids), slurries, powders and masses of small solids.

7. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   Pipe sizes can be confusing because the terminology may relate to historical dimensions. For example, a half-inch iron pipe does not have any dimension that is a half inch. Initially, a half inch pipe did have an inner diameter of 1 ⁄ 2 inch (13 mm)—but it also had thick walls. As technology improved, thinner walls became possible, but the ...