Search results
Results from the WOW.Com Content Network
Tuckpointing was a way of achieving a similar effect using cheap, unrubbed bricks; these were laid in a mortar of a matching colour (initially red, but later, blue-black bricks and mortar were occasionally used) and a fine fillet of white material, usually pipe clay or putty, pushed into the joints before the mortar set. [4]
The third, recessed, is when the mortar sits back from the face of the brick. There is also tuckpointing, where a mortar of a contrasting colour is 'tucked' into the masonry joint. If the color of the new mortar is still not similar to the old mortar after repointing and setting, the non-repointed areas of the structure can be cleaned.
A reglet is found on the exterior of a building along a masonry wall, chimney or parapet that meets the roof. It is a groove cut within a mortar joint that receives counter-flashing meant to cover surface flashing used to deflect water infiltration. Reglet can also refer to the counter-flashing itself when it is applied on the surface, known as ...
This joint is best used when the wall is intended to be plastered or joints are to be hidden under paint. Because the mortar is not compressed, it is less water-resistant than some of the other designs. Tuckpointing This joint has mortar colored to match the bricks surrounding a line of white mortar to make the joints look very small.
Mortar holding weathered bricks. Mortar is a workable paste which hardens to bind building blocks such as stones, bricks, and concrete masonry units, to fill and seal the irregular gaps between them, spread the weight of them evenly, and sometimes to add decorative colours or patterns to masonry walls.
Weatherproofing seam between a stone chimney and a tile roof on a building in Jersey, Channel Islands. The lead flashing is seen as light gray sheets at the base of the chimney. Flashing is thin pieces of impervious material installed to prevent the passage of water into a structure from a joint or as part of a weather resistant barrier system.
A brick chimney breast. A chimney breast is a portion of a chimney which projects forward from a wall to accommodate a fireplace. [1] Typically on the ground floor of a structure, the masonry extends upwards, containing a flue which carries smoke out of the building through a chimney stack. [2]
A chimney cowl or wind directional cap is a helmet-shaped chimney cap that rotates to align with the wind and prevent a downdraft of smoke and wind down the chimney. An H-style cap is a chimney top constructed from chimney pipes shaped like the letter H. It is an age-old method of regulating draft in situations where prevailing winds or ...