enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. File:Space elevator structural diagram--corrected for scale ...

   en.wikipedia.org/wiki/File:Space_elevator...

   This is an improved diagram of a Space Elevator. It is a modification of en:File:Space_elevator_structural_diagram--corrected_for_scale+CM+etc--regenerated_as_SVG.svg: Author: Skyway and User:Booyabazooka: Permission (Reusing this file) Same permissions as the file it's based on: File:Space_elevator_structural_diagram--corrected_for_scale+CM ...

3. Rack unit - Wikipedia

   en.wikipedia.org/wiki/Rack_unit

   Rack with sample component sizes including an A/V half-rack unit. A rack unit (abbreviated U or RU) is a unit of measure defined as 1 + 3 ⁄ 4 inches (44.45 mm). [1] [2] It is most frequently used as a measurement of the overall height of 19-inch and 23-inch rack frames, as well as the height of equipment that mounts in these frames, whereby the height of the frame or equipment is expressed ...

4. Elevator - Wikipedia

   en.wikipedia.org/wiki/Elevator

   Some types of residential elevators do not use a traditional elevator shaft, machine room, and elevator hoistway. This allows an elevator to be installed where a traditional elevator may not fit, and simplifies installation. The ASME board first approved machine-room-less systems in a revision of the ASME A17.1 in 2007.

5. Double-deck elevator - Wikipedia

   en.wikipedia.org/wiki/Double-deck_elevator

   Double-deck elevators at Midland Square, Nagoya, Japan The Bailong Elevator Symbol seen within the upper cabin of the elevator in Roppongi Hills Mori Tower Double lobby ("lower lobby" and "upper lobby") to enter the elevators in Roppongi Hills Mori Tower. A double-deck elevator or double-deck lift is an elevator where one cab is stacked on top ...

6. Engineering tolerance - Wikipedia

   en.wikipedia.org/wiki/Engineering_tolerance

   This is a standardised measure of the maximum difference in size between the component and the basic size (see below). For example, if a shaft with a nominal diameter of 10 mm is to have a sliding fit within a hole, the shaft might be specified with a tolerance range from 9.964 to 10 mm (i.e., a zero fundamental deviation, but a lower deviation ...

7. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

8. Preferred metric sizes - Wikipedia

   en.wikipedia.org/wiki/Preferred_metric_sizes

   A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard unit size of 200 mm square by 400 mm long. [3] A standard metric brick is 90 by 57 by 190 mm; with 10 mm of mortar, that produces a standard unit of 100 mm x 200 mm. [3]

9. Shaft (mechanical engineering) - Wikipedia

   en.wikipedia.org/wiki/Shaft_(mechanical_engineering)

   Toggle Standard sizes subsection. 3.1 Machine shafts. 3.2 Transmission shafts. 4 Stresses. ... In mechanical engineering, a shaft is a rotating machine element, ...