Search results
Results from the WOW.Com Content Network
Common uses for ifconfig include setting the IP address and subnet mask of a network interface and disabling or enabling an interface. [1] At boot time, many Unix-like operating systems initialize their network interfaces with shell scripts that call ifconfig. As an interactive tool, system administrators routinely use the utility to display ...
For example, you can release and renew an IP address if it happened to be assigned incorrectly by the DHCP server during the automated assignment process. [9] Like most Unix-based operating systems, Mac OS X also uses ifconfig for more direct control over network interfaces, such as configuring static IP addresses. The Ifconfig command in Linux ...
IP instances support DHCPv4 and IPv6 address autoconfiguration. An exclusive IP zone can have its own routing table and routing protocols separate from the global zone on a system. Moreover, a system administrator can run the ifconfig command within an exclusive IP instance to set up a logical interface within the exclusive IP zone.
ifconfig: ip addr, ip link: Address and link configuration route: ip route: Routing tables arp: ip neigh: Neighbors iptunnel: ip tunnel: Tunnels nameif, ifrename: ip link set name: Rename network interfaces ipmaddr: ip maddr: Multicast netstat: ss, ip route: Show various networking statistics brctl: bridge: Handle bridge addresses and devices
On Linux and all Unix-like operating systems, the utilities ifconfig and the newer ip (from the iproute2-bundle) are used to configure IEEE 802.3 and IEEE 802.11 hardware. These utilities configure the kernel directly and the configuration is applied immediately. After boot-up, the user is required to configure them again.
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
The network controller implements the electronic circuitry required to communicate using a specific physical layer and data link layer standard such as Ethernet or Wi-Fi. [a] This provides a base for a full network protocol stack, allowing communication among computers on the same local area network (LAN) and large-scale network communications through routable protocols, such as Internet ...
IP addresses are assigned to a host either dynamically as they join the network, or persistently by configuration of the host hardware or software. Persistent configuration is also known as using a static IP address. In contrast, when a computer's IP address is assigned each time it restarts, this is known as using a dynamic IP address.