Search results
Results from the WOW.Com Content Network
The IEEE symbol for the cubic foot per second is ft 3 /s. [1] The following other abbreviations are also sometimes used: ft 3 /sec; cu ft/s; cfs or CFS; cusec; second-feet; The flow or discharge of rivers, i.e., the volume of water passing a location per unit of time, is commonly expressed in units of cubic feet per second or cubic metres per second.
A standard cubic foot (scf) is a unit representing the amount of gas (such as natural gas) contained in a volume of one cubic foot at reference temperature and pressure conditions.
FT3 or ft3 may refer to: Cubic foot (ft 3) Finlayson Lake Airport; Free Triiodothyronine; Socket FT3 This page was last edited on 26 February 2016, at 17:41 (UTC ...
Oil conversion factor from m³ to bbl (or stb) is 6.28981100; Gas conversion factor from standard m³ to scf is 35.314666721; Note that the m³ gas conversion factor takes into account a difference in the standard temperature base for measurement of gas volumes in metric and imperial units.
Standard cubic feet per minute (SCFM) is the molar flow rate of a gas expressed as a volumetric flow at a "standardized" temperature and pressure thus representing a fixed number of moles of gas regardless of composition and actual flow conditions.
Actual cubic feet per minute (ACFM) is a unit of volumetric flow. It is commonly used by manufacturers of blowers and compressors. [1] This is the actual gas delivery with reference to inlet conditions, whereas cubic foot per minute (CFM) is an unqualified term and should only be used in general and never accepted as a specific definition without explanation.
Million standard cubic feet per day is a unit of measurement for gases that is predominantly used in the United States.It is frequently abbreviated MMSCFD. MMSCFD is commonly used as a measure of natural gas, liquefied petroleum gas, compressed natural gas and other gases that are extracted, processed or transported in large quantities.
Metric units are units based on the metre, gram or second and decimal (power of ten) multiples or sub-multiples of these. According to Schadow and McDonald, [1] metric units, in general, are those units "defined 'in the spirit' of the metric system, that emerged in late 18th century France and was rapidly adopted by scientists and engineers.