Search results
Results from the WOW.Com Content Network
The memory cell is the fundamental building block of computer memory. The memory cell is an electronic circuit that stores one bit of binary information and it must be set to store a logic 1 (high voltage level) and reset to store a logic 0 (low voltage level). Its value is maintained/stored until it is changed by the set/reset process.
SoftRAM was designed for use with Windows 3.1.It was launched in March 1995 and sold more than 100,000 copies. [2]Most out-of-memory errors in Windows 3.x were caused by the first megabyte of memory in a computer, the conventional memory, becoming full.
Virtual memory combines active RAM and inactive memory on DASD [a] to form a large range of contiguous addresses.. In computing, virtual memory, or virtual storage, [b] is a memory management technique that provides an "idealized abstraction of the storage resources that are actually available on a given machine" [3] which "creates the illusion to users of a very large (main) memory".
By reducing the I/O activity caused by paging requests, virtual memory compression can produce overall performance improvements. The degree of performance improvement depends on a variety of factors, including the availability of any compression co-processors, spare bandwidth on the CPU, speed of the I/O channel, speed of the physical memory, and the compressibility of the physical memory ...
Virtual memory systems abstract between physical RAM and virtual addresses, assigning virtual memory addresses both to physical RAM and to disk-based storage, expanding addressable memory, but at the cost of speed. NUMA and SMP architectures optimize memory allocation within multi-processor systems. While these technologies dynamically manage ...
OTP (one time programmable) memory is a special type of non-volatile memory (NVM) that permits data to be written to memory only once. Once the memory has been programmed, it retains its value upon loss of power (i.e., is non-volatile). OTP memory is used in applications where reliable and repeatable reading of data is required.
When physical memory is not full this is a simple operation; the page is written back into physical memory, the page table and TLB are updated, and the instruction is restarted. However, when physical memory is full, one or more pages in physical memory will need to be paged out to make room for the requested page.
Low-Power Double Data Rate (LPDDR), also known as LPDDR SDRAM, is a type of synchronous dynamic random-access memory (SDRAM) that consumes less power than other random access memory designs and is thus targeted for mobile computing devices such as laptop computers and smartphones. Older variants are also known as Mobile DDR, and abbreviated as ...