Search results
Results from the WOW.Com Content Network
The Davis & Shirtliff Group was founded in 1946 as a partnership between EC 'Eddie' Davis and FR 'Dick' Shirtliff after Dick Shirtliff purchased 50% of RH Paige & Co., a small plumbing and water engineering firm founded in 1926 and which was bought into by Eddie Davis in 1945.
A piston pump is a type of positive displacement pump where the high-pressure seal reciprocates with the piston. [1] Piston pumps can be used to move liquids or compress gases. They can operate over a wide range of pressures. High pressure operation can be achieved without adversely affecting flow rate. Piston pumps can also deal with viscous ...
Different types of pumps are suitable for different applications, for example: a pump's maximum lift height also determines the applications it can be used for. Low-lift pumps are only suitable for the pumping of surface water (e.g., irrigation, drainage of lands, ...), while high-lift pumps allow deep water pumping (e.g., potable water pumping ...
A treadle pump is a human-powered suction pump that sits on top of a well and is used for irrigation. [1] It is designed to lift water from a depth of seven metres or less. The pumping is activated by stepping up and down on a treadle , which are levers, which drive pistons, creating cylinder suction that draws groundwater to the surface.
Water reservoir - it is not a part of reciprocating pump, however, it is the main source where from the reciprocating pump takes the water. It may be a source of other fluid as well. Strainer - It removes all impurities from the liquid to avert chocking the pump. Suction Pipe - It is a pipe by which pump takes the water from the reservoir.
On the up stroke of the piston the foot valve opens and suction brings water into the pump head. On the following down stroke of the piston the valve on the piston opens up and allows water to flow above the piston. On the successive up stroke of the piston water is pushed out of the outlet. A rural handpump in Belgium.
Humphrey's pump consists of a large U-shaped tube, filled with water. One end is sealed by a heavy cast iron, or steel, 'combustion head'. The combustion head contains the inlet and exhaust valves, the ignition source and withstands the pressure of the combustion chamber. Water enters the pump through sprung inlet valves below the combustion ...
Axial piston pumps are used to power the hydraulic systems of jet aircraft, being gear-driven off of the turbine engine's main shaft, The system used on the F-14 used a 9-piston pump that produced a standard system operating pressure of 3000 psi and a maximum flow of 84 gallons per minute.