Search results
Results from the WOW.Com Content Network
In direct current (DC) circuits, this product is equal to the real power, measured in watts. [3] The volt-ampere is dimensionally equivalent to the watt: in SI units, 1 V⋅A = 1 W. VA rating is most used for generators and transformers, and other power handling equipment, where loads may be reactive (inductive or capacitive).
For example, if the load power factor were as low as 0.7, the apparent power would be 1.4 times the real power used by the load. Line current in the circuit would also be 1.4 times the current required at 1.0 power factor, so the losses in the circuit would be doubled (since they are proportional to the square of the current).
Typically a third conductor, called ground (or "safety ground") (U.S.) or protective earth (UK, Europe, IEC), is used as a protection against electric shock, and ordinarily carries significant current only when there is a circuit fault. [1] Several different earthing systems are in use.
Electric power is the rate of transfer of electrical energy within a circuit.Its SI unit is the watt, the general unit of power, defined as one joule per second.Standard prefixes apply to watts as with other SI units: thousands, millions and billions of watts are called kilowatts, megawatts and gigawatts respectively.
An electric heater is an electrical device that converts an electric current into heat. [1] The heating element inside every electric heater is an electrical resistor , and works on the principle of Joule heating : an electric current passing through a resistor will convert that electrical energy into heat energy.
In the UK a typical urban or suburban low-voltage substation would normally be rated between 150 kVA and 1 MVA and supply a whole neighbourhood of a few hundred houses. Transformers are typically sized on an average load of 1 to 2 kW per household, and the service fuses and cable is sized to allow any one property to draw a peak load of perhaps ...
In the power systems analysis field of electrical engineering, a per-unit system is the expression of system quantities as fractions of a defined base unit quantity. . Calculations are simplified because quantities expressed as per-unit do not change when they are referred from one side of a transformer to t
10 7: 1 × 10 7 W tech: highest ERP allowed for an UHF television station 1.03 × 10 7 W geo: electrical power output of Togo: 1.22 × 10 7 W tech: approx power available to a Eurostar 20-carriage train 1.5 × 10 7 W tech: electrical power consumption of Sunway TaihuLight, the most powerful supercomputer in China 1.6 × 10 7 W