Search results
Results from the WOW.Com Content Network
A pulley is a wheel on an axle or shaft enabling a taut cable or belt passing over the wheel to move and change direction, or transfer power between itself and a shaft. A sheave or pulley wheel is a pulley using an axle supported by a frame or shell (block) to guide a cable or exert force.
Underdrive is the slowing of the rate of rotation in a system, achieved by either making the crank or main (drive) pulley smaller or making the accessory (driven) pulley larger than the original diameter pulleys. Underdrive pulleys increase engine output by reducing the draw of the engine's accessories by slowing them down and reducing the ...
The fixed pulley on the upper shaft is driven at constant speed by a belt from the power source. The loose pulley ('idler') allows the machine to be stopped in isolation – necessary for changing speed. The stepped pulleys (left) provide three drive speeds for the machine tool (not shown), depending on which pair of pulleys is connected by the ...
Belts are looped over pulleys and may have a twist between the pulleys, and the shafts need not be parallel. In a two pulley system, the belt can either drive the pulleys normally in one direction (the same if on parallel shafts), or the belt may be crossed, so that the direction of the driven shaft is reversed (the opposite direction to the ...
The Engine was available with a 5 speed manual & 4 speed automatic transmission. Available in both fuel injected and carburetted configurations, the 7K produces much more power and torque compared to the other K engines however it is a lot less 'rev happy' due to having such a long stroke.
A timing mark is an indicator used for setting the timing of the ignition system of an engine, typically found on the crankshaft pulley (as pictured) or the flywheel. [1] These have the largest radius rotating at crankshaft speed and therefore are the place where marks at one degree intervals will be farthest apart.
The Suzuki K engine family is a series of automobile engines from Suzuki, introduced in 1994. Displacements range from 0.7 L to 1.5 L. Displacements range from 0.7 L to 1.5 L. All engines have aluminium cylinder blocks with three or four cylinders in-line.
The 1KZ-T is a version of the KZ series engine that used a fully mechanical injector pump instead, 3.0 L (2,982 cc), 4 cylinders, SOHC, 2 valve per cylinder turbo diesel engine. Compression ratio remains the same at 21.2:1. Maximum output is 123 hp (92 kW; 125 PS) at 3600 rpm and maximum torque is 296 N⋅m (218 lb⋅ft) at 2000 rpm. [1]