Search results
Results from the WOW.Com Content Network
Instead of block-downconverting the whole received spectrum, an SCR LNB downconverts a small section of the received signal (equivalent to the bandwidth of a single transponder on the satellite) selected according to a DiSEqC-compliant command from the receiver, to output at a fixed frequency in the IF. Up to 32 tuners can be allocated a ...
A twin-output Duo LNB fitted to a 60 cm dish with only one output connected. (Note that this LNB is mounted using the 19.2°E feedhorn, not in accordance with SES' installation guidelines) A Duo LNB is a double low-noise block downconverter (LNB) developed by SES for the simultaneous reception of satellite television signals from both the Astra ...
Two monoblock LNB can be connected to one receiving dish using Multi-satellite techniques. However, the expected results of such connections may vary or be sub-optimal. The results may yield low-level signals from some or all of the satellites or it may work well in certain geographically favorable locations.
In the LNB they become down converted to 950–2150 MHz, which is the frequency range allocated for the satellite service on the coaxial cable between LNBF and receiver. Lower frequencies are allocated to cable and terrestrial TV , FM radio, etc.
The individual LNB's in the package may be standard (DC voltage selects polarisation) or stacked (both polarisations output at once, on different frequency). If the package contains a switch, it would either use 22 kHz to switch between two satellites (DirecTV, StarChoice) or use a proprietary switch (EchoStar/DishNetwork).
In the box at the focus of the dish, called a low-noise block downconverter (LNB), each block of frequencies is converted to the IF range of 950–2150 MHz by two fixed frequency local oscillators at 9.75 and 10.6 GHz. One of the two blocks is selected by a control signal from the set top box inside, which switches on one of the local oscillators.
It consists of all the components in the receiver that process the signal at the original incoming radio frequency (RF), before it is converted to a lower intermediate frequency (IF). In microwave and satellite receivers it is often called the low-noise block downconverter (LNB) and is often located at the antenna, so that the signal from the ...
Feed horn with concentric rings (left) and LNB (right) on a Hughes DirecWay home satellite dish. An LNBF (LNB with integrated feed horn) that has been cut into two.Visible is the scalar horn antenna (the funnel with concentric rings), which couples the microwave beam into a short waveguide (the tube connecting the feed horn to the LNB electronics part of the LNBF).