Search results
Results from the WOW.Com Content Network
Instead of block-downconverting the whole received spectrum, an SCR LNB downconverts a small section of the received signal (equivalent to the bandwidth of a single transponder on the satellite) selected according to a DiSEqC-compliant command from the receiver, to output at a fixed frequency in the IF. Up to 32 tuners can be allocated a ...
A twin-output Duo LNB fitted to a 60 cm dish with only one output connected. (Note that this LNB is mounted using the 19.2°E feedhorn, not in accordance with SES' installation guidelines) A Duo LNB is a double low-noise block downconverter (LNB) developed by SES for the simultaneous reception of satellite television signals from both the Astra ...
A satellite finder (or sat finder) is a satellite field strength meter used to accurately point satellite dishes at communications satellites in geostationary orbit. [ 14 ] [ 15 ] [ 16 ] Professional satellite finder meters allow better dish alignment and provide received signal parameter values as well.
A virtual LNB with four electrical outputs for four tuners. The complete spectrum of Ku-band satellite reception stretches from 10.70 GHz-12.75 GHz across two signal polarisations, or a bandwidth of about 4000 MHz. This cannot be carried on a single coaxial cable and so in a conventional satellite reception system, just one of four sub-bands ...
Special LNBs have been developed for use in single-cable distribution systems. All four sub-bands of the Ku band (low frequency/horizontal polarity, high frequency/horizontal polarity, low frequency/vertical polarity, high frequency/vertical polarity) are received by a conventional front end, amplified and downconverted to the L-band, to be fed to a number of SatCR (Satellite Channel Router ...
A "stacked" LNB (both polarisations output at once on different frequencies) on a single satellite needs only a signal splitter, not a true multiswitch. The splitter must be able to pass DC power from one of the receivers to the LNB without interference.
Two monoblock LNB can be connected to one receiving dish using Multi-satellite techniques. However, the expected results of such connections may vary or be sub-optimal. The results may yield low-level signals from some or all of the satellites or it may work well in certain geographically favorable locations.
Similarly, a signal received from a satellite is firstly downconverted (this is done by a Low-noise block converter - LNB), then demodulated by a modem, and at last handled by data terminal equipment. The LNB is usually powered by the modem through the signal cable with 13 or 18 V DC.