Search results
Results from the WOW.Com Content Network
Nernst lamps did not use a glowing tungsten filament. Instead, they used a ceramic rod that was heated to incandescence.Because the rod (unlike tungsten wire) would not further oxidize when exposed to air, there was no need to enclose it within a vacuum or noble gas environment; the burners in Nernst lamps could operate exposed to the air and were only enclosed in glass to isolate the hot ...
Group 2 (Only for use in signalling lamps, cornering lamps, reversing lamps and rear registration plate lamps) Category Cap (Base) Filaments Nominal Power (Major/Minor where applicable) Comments Image C5W SV8.5 1 6 V, 12 V, 24 V: 5 W [5] ECE nominal luminous flux: 45 lm ± 20%; Old designation: C11, common name is "festoon" base H6W BAX9s 1 12 ...
A closeup of a 175-W mercury-vapor lamp. The small diagonal cylinder at the bottom of the arc tube is a resistor which supplies current to the starter electrode. A mercury-vapor lamp is a gas-discharge lamp that uses an electric arc through vaporized mercury to produce light. [1]
As they heat up during operation, however, the internal gas pressure within the arc tube rises and a higher voltage is required to maintain the arc discharge. As a lamp gets older, the voltage necessary to maintain the arc eventually rises to exceed the voltage provided by the electrical ballast. As the lamp heats to this point, the arc fails ...
The introduction of the metal vapor lamp, including various metals within the discharge tube, was a later advance. The heat of the gas discharge vaporizes some of the metal and the discharge is then produced almost exclusively by the metal vapor. The usual metals are sodium and mercury owing to their visible spectrum emission.
A balanced-arm lamp has a base, a stand or body, (in most cases) two connected arms (in many cases fitted with springs), and a lamp-head. The lamp can be moved into almost any position, and the balancing device will maintain the position until moved again. The same overall mechanism can be employed in other devices with similar requirements ...
A high-pressure sodium street light in Toronto A high-pressure sodium-vapor lamp An HPS lamp that isn't entirely off. A sodium-vapor lamp is a gas-discharge lamp that uses sodium in an excited state to produce light at a characteristic wavelength near 589 nm. Two varieties of such lamps exist: low pressure, and high pressure.
An infrared heater or heat lamp is a heating appliance containing a high-temperature emitter that transfers energy to a cooler object through electromagnetic radiation. Depending on the temperature of the emitter, the wavelength of the peak of the infrared radiation ranges from 750 nm to 1 mm.