Search results
Results from the WOW.Com Content Network
The transfer case has no center differential, so power can only be supplied to the front axle when the rear wheels begin to slip. In this way, the transfer case works almost identically to the NV247 transfer case used in the Quadra-Trac II system in 1999 to 2004 WJ Jeep Grand Cherokees.
The TH400 AMC case was used until the end of 1979 model production. The 232 cu in (3.8 L) I6 used in 1970-72 Jeep DJ "Postal Jeep" was backed up by the Borg-Warner T-35 3-speed automatic. At the time of the acquisition, Kaiser-Jeep was using a GM 2-speed Powerglide transmission in the DJ-5A (with the GM-sourced 2.5L I4).
Inside of a 231 New Process Gear transfer case. Part-time/Manual, shift on the fly Part-time/Manual, shift on the fly A transfer case is an intermediate gearbox that transfers power from the transmission of a motor vehicle to the driven axles of four-wheel-drive , all-wheel-drive , and other multi-axled on- and off-road machines.
The NV247 all-wheel drive transfer case, sold by Chrysler's Jeep division as the "Quadra-Trac II," the manual transaxle for the Dodge Neon and PT Cruiser (T-350), and manual transaxles for European-export Chrysler minivans (T-650 and T-750) were the bulk of the plant's last years of production.
A transmission control unit (TCU), also known as a transmission control module (TCM), or a gearbox control unit (GCU), is a type of automotive ECU that is used to control electronic automatic transmissions. Similar systems are used in conjunction with various semi-automatic transmissions, purely for clutch automation and actuation.
The Jeep Forward Control is a truck that was produced by Willys Motors, later named Kaiser Jeep, from 1956 to 1965. It was also assembled in other international markets. The layout featured a cab over (forward control) design. The Forward Control models were primarily marketed as corporate, municipal, military, and civilian work vehicles.
The most recent addition to the ITAS system is the ITAS-FTL (far target location), which incorporates a new module called PADS (position attitude determination subsystem), a device that attaches to the top of the ITAS sighting unit and uses differential GPS tracking to relay precise coordinate data to the operator.
As an intermediate mode, "Auto" mode allowed software to control the torque sent to the front wheels; if the rear axle began to spin, torque was shifted from the rear wheels to the front wheels until traction is achieved. The manually operated hubs and manual transfer cases were discontinued.