Search results
Results from the WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Some engine control units (ECUs) also control the throttle position by electronic throttle control (ETC) or "drive by wire" systems, and if that is done, the position sensor is used in a feedback loop to enable that control. [1] Related to the TPS are accelerator pedal sensors, which often include a wide open throttle (WOT) sensor.
While conventional traction control systems at the time featured only a slip control function, Mitsubishi's TCL system had an active safety function, which improved course tracing performance by automatically adjusting the traction force (called "trace control"), thereby restraining the development of excessive lateral acceleration while turning.
The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.
Atomic Gravitational Wave Interferometric Sensor; Attitude control (spacecraft): Horizon sensor, Earth sensor, Moon sensor, Satellite Sensor, Sun sensor; Catadioptric sensor; Chemoreceptor; Compressive sensing; Cryogenic particle detectors; Dew warning; Diffusion tensor imaging; Digital holography; Electronic tongue; Fine Guidance Sensor; Flat ...
Using electronic stability control sensors to measure steering angle, vehicle yaw, and lateral acceleration and brake assist (BAS) sensors to detect emergency braking, the system can tighten the seat belts, adjust seat positions, including rear seats (if installed), raise folded rear headrests (if installed), and close the sunroof if it detects ...
The three-axis acceleration switch is a micromachined microelectromechanical systems (MEMS) sensor that detects whether an acceleration event has exceeded a predefined threshold. [1] It is a small, compact device, only 5mm by 5mm, and measures acceleration in the x, y, and z axes. [ 2 ]
Electronic throttle control, throttle position sensor fault or cruise control failure (see drive by wire) [11] Stuck throttle (unrelated to pedal position) [12] [13] Shorting of tin whiskers [14] [15] Diesel engine runaway: Diesel engine power is governed by the amount of fuel supplied. Excessive pressure in the crankcase can force mist of ...