Search results
Results from the WOW.Com Content Network
Wavenumber, as used in spectroscopy and most chemistry fields, is defined as the number of wavelengths per unit distance, typically centimeters (cm −1): ~ =, where λ is the wavelength. It is sometimes called the "spectroscopic wavenumber". [1] It equals the spatial frequency.
The phase velocity at which electrical signals travel along a transmission line or other cable depends on the construction of the line. Therefore, the wavelength corresponding to a given frequency varies in different types of lines, thus at a given frequency different conductors of the same physical length can have different electrical lengths.
Spatial frequency is a reciprocal length, which can thus be used as a measure of energy, usually of a particle. For example, the reciprocal centimetre, cm −1, is an energy unit equal to the energy of a photon with a wavelength of 1 cm. That energy amounts to approximately 1.24 × 10 −4 eV or 1.986 × 10 −23 J.
Electromagnetic radiation with a wavelength between 380 nm and 760 nm (400–790 terahertz) is detected by the human eye and perceived as visible light. Other wavelengths, especially near infrared (longer than 760 nm) and ultraviolet (shorter than 380 nm) are also sometimes referred to as light, especially when the visibility to humans is not ...
1,1-disub. alkenes 1655 medium cis-1,2-disub. alkenes 1660 medium trans-1,2-disub. alkenes 1675 medium trisub., tetrasub. alkenes 1670 weak conjugated C═C dienes 1600 strong 1650 strong with benzene ring 1625 strong with C═O 1600 strong C═C (both sp 2) any 1640–1680 medium aromatic C═C any 1450 weak to strong (usually 3 or 4) 1500 1580
The length of the line would then be scaled to P 1 assuming the Smith chart radius to be unity. For example, if the actual radius measured from the paper was 100 mm, the length OP 1 would be 63 mm. The following table gives some similar examples of points which are plotted on the Z Smith chart. For each, the reflection coefficient is given in ...
This can be ensured by making the load impedance equal to Z 0, in which case the transmission line is said to be matched. A transmission line is drawn as two black wires. At a distance x into the line, there is current I(x) travelling through each wire, and there is a voltage difference V(x) between the wires.
siemens (S = Ω −1) L −2 M −1 T 3 I 2: scalar Electrical conductivity: σ: Measure of a material's ability to conduct an electric current S/m L −3 M −1 T 3 I 2: scalar Electric potential: φ: Energy required to move a unit charge through an electric field from a reference point volt (V = J/C) L 2 M T −3 I −1: extensive, scalar ...