Search results
Results from the WOW.Com Content Network
Interior of a Boeing/Stearman PT-17 showing small channel section stringers. In engineering, a longeron or stringer is a load-bearing component of a framework. The term is commonly used in connection with aircraft fuselages and automobile chassis. Longerons are used in conjunction with stringers to form structural frameworks. [1]
Wing ribs of a de Havilland DH.60 Moth. In an aircraft, ribs are forming elements of the airframe structure of a wing, especially in traditional construction.. By analogy with the anatomical definition of "rib", the ribs attach to the main spar, and by being repeated at frequent intervals, form a skeletal shape for the wing.
The spar carries flight loads and the weight of the wings while on the ground. Other structural and forming members such as ribs may be attached to the spar or spars, with stressed skin construction also sharing the loads where it is used. There may be more than one spar in a wing or none at all.
The internal structure comprises stringers, spars, bulkheads, chord members, and various attaching fittings made of aluminum extrusions, formed sheet, forgings, and castings. The alloys most used for extruded members are 2024-T4 for sections less than 0.125 in. thick and for general application, and 2014-T6 for thicker, more highly stressed ...
The wings were single bay of equal spans and wire braced. The upper wing was made in one piece and constructed with two solid Spruce spars. Ailerons were found only on the bottom wings. Stamped aluminium alloy ribs were used to construct the wings and steel-tube compression struts were at the interplane and centre section of the wings.
While internal wing structure commonly provides much of the strength via a combination of spars, ribs and stringers, the external skin typically carries a proportion of the loads too. On many aircraft, the inner volume of the wingbox has also been used to store fuel, which is commonly referred to as being a wet wing design. [1]
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Due to the stiffness of the wooden frame, several traditional glider parts, including ribs, stringer, frames, and spars, were eliminated. Although this method significantly reduced the cost and weight of the glider, until then this design had only been used in military aircraft, including the Bachem Ba 349 Natter and the Focke-Wulf Ta 154 .