Search results
Results from the WOW.Com Content Network
An N-MOSFET/IGBT needs a significantly positive charge (V GS > V th) applied to the gate in order to turn on. Using only N-channel MOSFET/IGBT devices is a common cost reduction method due largely to die size reduction (there are other benefits as well). However, using nMOS devices in place of pMOS devices means that a voltage higher than the ...
Figure 3 shows a MOSFET common-source amplifier with an active load. Figure 4 shows the corresponding small-signal circuit when a load resistor R L is added at the output node and a Thévenin driver of applied voltage V A and series resistance R A is added at the input node.
In most circuits, this means pulling an enhancement-mode MOSFET's gate voltage towards its drain voltage turns it on. In a depletion-mode MOSFET, the device is normally on at zero gate–source voltage. Such devices are used as load "resistors" in logic circuits (in depletion-load NMOS logic, for example).
If the MOSFET is an n-channel or nMOS FET, then the source and drain are n+ regions and the body is a p region. If the MOSFET is a p-channel or pMOS FET, then the source and drain are p+ regions and the body is a n region. The source is so named because it is the source of the charge carriers (electrons for n-channel, holes for p-channel) that ...
Cross-sectional view of a MOSFET type field-effect transistor, showing source, gate and drain terminals, and insulating oxide layer.. The field-effect transistor (FET) is a type of transistor that uses an electric field to control the current through a semiconductor.
Overdrive voltage, usually abbreviated as V OV, is typically referred to in the context of MOSFET transistors.The overdrive voltage is defined as the voltage between transistor gate and source (V GS) in excess of the threshold voltage (V TH) where V TH is defined as the minimum voltage required between gate and source to turn the transistor on (allow it to conduct electricity).
In short-channel devices this is no longer true: The drain is close enough to gate the channel, and so a high drain voltage can open the bottleneck and turn on the transistor prematurely. The origin of the threshold decrease can be understood as a consequence of charge neutrality: the Yau charge-sharing model. [ 1 ]
A current mirror is a circuit designed to copy a current through one active device by controlling the current in another active device of a circuit, keeping the output current constant regardless of loading. The current being "copied" can be, and sometimes is, a varying signal current.