Search results
Results from the WOW.Com Content Network
The fuse is protected by a sliding plastic cover, which requires the power lead to be removed before it can be opened. A power entry module (PEM) is an electromechanical component used in electrical appliances, integrating the appliance inlet with other components such as: a switch, possibly including integrated or remote bowden cable actuation;
The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.
The sensor has an input port to measure the hydraulic braking pressure and an electrical connector output for a wire connection for feeding the warning light. Some brake failures do not trip the sensor into a fault mode. A brake fluid pressure sensor is used in anti-lock braking system (ABS). ABS fault lights come on with unexpected wheel lock ...
NEMA contact ratings are how much current at a rated voltage a relay or other pilot device can switch. The current rating of smaller NEMA contactors or their auxiliaries are defined by NEMA ICS 5: Industrial Control and Systems, Control Circuit and Pilot Devices [1] standard. The nomenclature is a letter followed by a three-digit number, the ...
A PTO at the rear end of a farm tractor A PTO (in the box at the bottom) in the center of the three-point hitch of a tractor. A power take-off or power takeoff (PTO) is one of several methods for taking power from a power source, such as a running engine, and transmitting it to an application such as an attached implement or separate machine.
The Wärtsilä RT-flex96C is a two-stroke turbocharged low-speed diesel engine designed by the Finnish manufacturer Wärtsilä.It is designed for large container ships that run on heavy fuel oil.
Cable entry systems are used for routing electrical cables, corrugated conduits or pneumatic and hydraulic hoses into switch cabinets, electrical enclosures, control panels and machines or in large heavy-duty vehicles, rolling stock and ships. Possible requirements can be high ingress protection rates or integrated strain relief. [1]
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...