Ad
related to: difference between bhp and torque converter in vehicles meaning chart
Search results
Results from the WOW.Com Content Network
At stall, the torque converter can produce maximum torque multiplication if sufficient input power is applied (the resulting multiplication is called the stall ratio). The stall phase actually lasts for a brief period when the load (e.g., vehicle) initially starts to move, as there will be a very large difference between pump and turbine speed.
The typical torque converter of the time was about 11.5in. long and the torque multiplication ratio was about 1.5 to 1. The N360/N600 torque converter was about 5.5in. long and achieved a torque multiplication of over 2.2 to 1. The first Civic was equipped with a manually changed hydraulically engaged two-speed transmission with a torque converter.
The early model C4 (1964–1969) used a .788-inch 24-spline input shaft, which was upgraded in 1970 to 26-spline and .839-inch. The upgrade also included a matching 26-spline clutch hub. In 1971, Ford went to a 26/24-spline input shaft, meaning the torque-converter side is 26-spline and the clutch hub is 24-spline.
Horsepower (hp) is a unit of measurement of power, or the rate at which work is done, usually in reference to the output of engines or motors. There are many different standards and types of horsepower.
This happened in 1993 for trucks, vans, and SUVs, and 1994 for rear wheel drive passenger cars. In 1996, a bolt-on bell housing was phased in (along with a six-bolt tailhousing) for S-10 Trucks and S-10 Blazers and beginning in 1998 for all other applications. Beginning in 1998 a new 300mm torque converter with improved higher-capacity ...
There are also problems with the valve block and solenoids [citation needed] When this failure starts to occur, shift quality and speed, torque transfer and even loss of ability to engage gears can occur. These problems led Volkswagen Group to extend the warranty on all of their vehicles equipped with this transmission to 100,000 miles or 10 years.
Three-speed gear set with torque converter, air-cooled. Used in the Rambler American 6-cylinder cars between 1963 and 1969 as "Flash-O-Matic." Borg-Warner M40, M42, M43, and M44. 3-speed with torque converter, water-cooled. Used in AMC 6- and V8 engines between 1970 and 1971; also the 290 2-bbl V8 engine between 1967 and 1969 (M40).
For the 1981 model year, a lock-up torque converter was introduced which coincided with the new EMC control of most GM cars; this version is the THM350-C, which was phased out in 1984 in GM passenger cars for the 700R4. Chevrolet/GMC trucks and vans used the THM350-C until 1986. The lock-up torque converter was unpopular with transmission builders.
Ad
related to: difference between bhp and torque converter in vehicles meaning chart