Search results
Results from the WOW.Com Content Network
With the AETC system, the power-valve systems are normally partially closed at low RPM; when closed, it enables the engine to make more power. Up to a certain point, however, power drops off as the engine is unable to expel enough gases out of the exhaust. When the power-valve is opened, it allows more gases to flow out of the exhaust port.
A four-stroke power valve is a device fitted to four-stroke engines that constantly adjusts the internal diameter of the exhaust system to better suit the speed of the engine. Yamaha was the first to develop such a system, called the Exhaust Ultimate Power Valve (EXUP). [1] It first appeared on the Yamaha FZR EXUP and was later used on many ...
The Casablanca-class escort carrier, the most prolific aircraft carrier design in history, used two 5-cylinder Skinner Unaflow engines, but these were not steeple compounds. A non-compound Skinner Uniflow remained in service until 2013 in the Great Lakes cement carrier SS St. Marys Challenger, installed when the vessel was re-powered in 1950 ...
The Ford Modular V8 engines and the V6 Cologne use either the Intake Manifold Runner Control (IMRC) for four-valve engines, or the Charge Motion Control Valve (CMCV) for three-valve engines. The SVT edition (in North America) and ST170 edition (in Europe) of the Ford Focus added IMRC to the Ford Zetec engine .
The RV-7 incorporated many changes resulting from the lessons learned in producing over 2,000 RV-6 kits. The RV-7 airframe will accept larger engines, including the Lycoming IO-390, up to 215 hp (160 kW). [8] The RV-7 also has increased wingspan and wing area over the RV-6, as well as more headroom, legroom and an increased useful load.
The automobile self starter was an early engine system to use this. Lighting, which had previously been provided by kerosene lamps or gas lamps, was one of the first common electrical accessories. Early systems used 6 volts, but 12 volts became the standard because it provided greater power with less current.
A Corliss steam engine – the valve gear is on the right of the cylinder block, on the left of the picture. A Corliss steam engine (or Corliss engine) is a steam engine, fitted with rotary valves and with variable valve timing patented in 1849, invented by and named after the US engineer George Henry Corliss of Providence, Rhode Island.
A small transformer potted in epoxy. The surface visible on the right is formed by the potting compound that has been poured into the plastic box. In electronics, potting is the process of filling a complete electronic assembly with a solid or gelatinous compound.