Search results
Results from the WOW.Com Content Network
Finally, the stiffeners increase the resistance of the plate to buckling. The same structural effects are also true of the concrete slab in a composite girder bridge, but the steel orthotropic deck is considerably lighter, and therefore allows longer span bridges to be more efficiently designed.
A rigid line inclusion, also called stiffener, is a mathematical model used in solid mechanics to describe a narrow hard phase, dispersed within a matrix material.This inclusion is idealised as an infinitely rigid and thin reinforcement, so that it represents a sort of ‘inverse’ crack, from which the nomenclature ‘anticrack’ derives.
An SPW frame can be idealized as a vertical cantilever plate girder, in which the steel plates act as the web, the columns act as the flanges and the cross beams represent the transverse stiffeners. The theory that governs plate design should not be used in the design of SPW structures since the relatively high bending strength and stiffness of ...
The stiffeners are usually considered pinned end. Power plant ductwork can be 5/16" thick duct plate, with "fixed end" W stiffeners at roughly 2'-5" spacing. Because rectangular duct plate bends, stiffeners are required at reasonably close spacing. Duct plate 3/16", or thinner, may dishpan, or make noise, and should be avoided.
For example, in the case of design for fire a load case of 1.0 x Dead Load + 0.8 x Live Load may be used, as it is reasonable to assume everyone has left the building if there is a fire. In multi-story buildings it is normal to reduce the total live load depending on the number of stories being supported, as the probability of maximum load ...
Two-dimensional elements that resist only in-plane forces by membrane action (plane stress, plane strain), and plates that resist transverse loads by transverse shear and bending action (plates and shells). They may have a variety of shapes such as flat or curved triangles and quadrilaterals. Nodes are usually placed at the element corners, and ...
In continuum mechanics, plate theories are mathematical descriptions of the mechanics of flat plates that draw on the theory of beams. Plates are defined as plane structural elements with a small thickness compared to the planar dimensions. [1] The typical thickness to width ratio of a plate structure is less than 0.1.
For rectangular plates, Navier in 1820 introduced a simple method for finding the displacement and stress when a plate is simply supported. The idea was to express the applied load in terms of Fourier components, find the solution for a sinusoidal load (a single Fourier component), and then superimpose the Fourier components to get the solution ...