Ad
related to: one pipe vs two steam turbine
Search results
Results from the WOW.Com Content Network
Steam's starting pressure and temperature is the same for both the actual and the ideal turbines, but at turbine exit, steam's energy content ('specific enthalpy') for the actual turbine is greater than that for the ideal turbine because of irreversibility in the actual turbine.
A compound steam engine unit is a type of steam engine where steam is expanded in two or more stages. [ 1 ] [ 2 ] A typical arrangement for a compound engine is that the steam is first expanded in a high-pressure (HP) cylinder , then having given up heat and losing pressure, it exhausts directly into one or more larger-volume low-pressure (LP ...
A multi-shaft system usually has only one steam system for up to three gas turbines. Having only one large steam turbine and heat sink has economies of scale and can have lower cost operations and maintenance. A larger steam turbine can also use higher pressures, for a more efficient steam cycle.
There is usually a high-pressure turbine at one end, followed by an intermediate-pressure turbine, and finally one, two, or three low-pressure turbines, and the shaft that connects to the generator. As steam moves through the system and loses pressure and thermal energy, it expands in volume, requiring increasing diameter and longer blades at ...
In the energy-rich Persian Gulf region, the steam from the HRSG is used for desalination plants. [1] Universities are ideal candidates for HRSG applications. They can use a gas turbine to produce high-reliability electricity for campus use. The HRSG can recover the heat from the gas turbine to produce steam/hot water for district heating or ...
In commercial power plants, there are two to four steam generators per reactor; each steam generator can measure up to 70 feet (21 m) in height and weigh as much as 800 tons. Each steam generator can contain anywhere from 3,000 to 16,000 tubes, each about .75 inches (19 mm) in diameter.
The difference between the heat of steam per unit mass at the inlet to the turbine and the heat of steam per unit mass at the outlet from the turbine represents the heat which is converted to mechanical power. Therefore, the more the conversion of heat per pound or kilogram of steam to mechanical power in the turbine, the better is its ...
Steam locomotives were tested in the past but were not ideal for low speeds, and gas turbine locomotives were used by Union Pacific until the 1970s. [1] Combined cycle power uses the heat from the gas turbine to make steam from the water to turn a steam turbine, instead of that heat getting exhausted out and wasted.
Ad
related to: one pipe vs two steam turbine