enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Groove (joinery) - Wikipedia

   en.wikipedia.org/wiki/Groove_(joinery)

   A groove can be cut by the following methods: electric router using a straight or rebate bit; circular saw with multiple passes (depending on width and depth) dado set in a single pass; spindle moulder (wood shaper) hand saw and chisel; router plane; grooving plane

3. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   There are two standard types of router—plunge and fixed. When using a plunge-base router, the sole of the base is placed on the face of the work with the cutting bit raised above the work, then the motor is turned on and the cutter is lowered into the work. With a fixed-base router, the cut depth is set before the tool is turned on. The sole ...

4. Dado (joinery) - Wikipedia

   en.wikipedia.org/wiki/Dado_(joinery)

   A dado (US and Canada, / ˈ d eɪ d oʊ /), housing (UK) or trench (Europe) is a slot or trench cut into the surface of a piece of machinable material, usually wood. When viewed in cross-section, a dado has three sides. A dado is cut across, or perpendicular to, the grain and is thus differentiated from a groove which

5. Rift sawing - Wikipedia

   en.wikipedia.org/wiki/Rift_sawing

   The AWI defines "rift sawing" as a technique of cutting boards from logs so the grain is between 30–60° to the face of the board, with 45 degrees being "optimum". [2] In Understanding Wood , Hoadley describes "rift grain" as occurring at an angle between 45–90° to the surface, and describes the AWI definition as "bastard sawn".

6. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Framing side by side units The erection of a wooden frame in Sabah, Malaysia The construction frames of a residential subdivision in Rogers, Minnesota in 2023. Framing, in construction, is the fitting together of pieces to give a structure, particularly a building, support and shape. [1]

7. Flat sawing - Wikipedia

   en.wikipedia.org/wiki/Flat_sawing

   Lumber can be quickly flat-cut with a side-by-side set of mechanical saws. [3] A slower but sturdier method involves passing the log back and forth over a single saw. To reduce buckling that may occur along the middle of flat-cut boards, the initial cut may be offset from the diameter, and resulting sections cut further before cutting the flitches.