Search results
Results from the WOW.Com Content Network
The .375 Ruger (9.5×65.5mm) is a rimless, standard-length rifle cartridge designed for hunting large, dangerous game. It is designed to provide an increase in performance over the .375 H&H cartridge within the context of a standard-length rifle action.
The .375 H&H Magnum, also known as .375 Holland & Holland Magnum, is a medium-bore rifle cartridge introduced in 1912 by London based gunmaker Holland & Holland. [2] The .375 H&H cartridge featured a belt to ensure the correct headspace, which otherwise might be unreliable, given the narrow shoulder of the cartridge case. [3]
The traditional typographic units are based either on non-metric units, or on odd multiples (such as 35 ⁄ 83) of a metric unit.There are no specifically metric units for this particular purpose, although there is a DIN standard sometimes used in German publishing, which measures type sizes in multiples of 0.25 mm, and proponents of the metrication of typography generally recommend the use of ...
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. [citation needed] For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any ...
The .408 Cheyenne Tactical is based on the .400 Taylor Magnum, which itself is based on a modified .505 Gibbs, necked down to 0.408 inches (10.36 mm). The .505 Gibbs is an old English big-game cartridge that was designed to accommodate 39,160 psi (270 MPa) pressure.
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...