Search results
Results from the WOW.Com Content Network
The Arduino Uno is a series of open-source microcontroller board based on a diverse range of microcontrollers (MCU). It was initially developed and released by Arduino company in 2010. [ 2 ] [ 3 ] The microcontroller board is equipped with sets of digital and analog input/output (I/O) pins that may be interfaced to various expansion boards ...
Arduino Uno compatible board powered by ATmega2560. D0/D1 can be changed to D19/D18. It enables to multiple serial communication. [132] A4/A5 are not connected to SDA/SCL same as Arduino Mega. Mega 2560 PRO (Embed) ATmega2560-16AU RobotDyn: Embed version of Mega 2560 CH340G/ATmega2560 - compatible with Arduino Mega 2560 board.
Arduino-compatible R3 Uno board with no Arduino logo. Arduino is open-source hardware. The hardware reference designs are distributed under a Creative Commons Attribution Share-Alike 2.5 license and are available on the Arduino website. Layout and production files for some versions of the hardware are also available.
Arduino Mega compatible board with 16 extra I/O pins and the same a board size as the Arduino Uno. As with the Arduino Mega, most shields that were designed for the Duemilanove, Diecimila, or Uno will fit, but a few shields will not fit because of interference with the extra pins.
The Arduino Nano is an open-source breadboard-friendly microcontroller board based on the Microchip ATmega328P microcontroller (MCU) and developed by Arduino.cc and initially released in 2008. It offers the same connectivity and specs of the Arduino Uno board in a smaller form factor.
A schematic, or schematic diagram, is a designed representation of the elements of a system using abstract, graphic symbols rather than realistic pictures. A schematic usually omits all details that are not relevant to the key information the schematic is intended to convey, and may include oversimplified elements in order to make this essential meaning easier to grasp, as well as additional ...
The STK600 uses a base board, a signal routing board, and a target board. The base board is similar to the STK500, in that it provides a power supply, clock, in-system programming, an RS-232 port and a CAN (Controller Area Network, an automotive standard) port via DE9 connectors, and stake pins for all of the GPIO signals from the target device.
Top of a copper clad Perfboard with solder pads for each hole. Perfboard is a material for prototyping electronic circuits.It is a thin, rigid sheet with holes pre-drilled at standard intervals across a grid, usually a square grid of 0.1 inches (2.54 mm) spacing.