Search results
Results from the WOW.Com Content Network
A set of three water pressure measurements are recorded from two hydrants. One hydrant is known as the residual hydrant or test hydrant and is located on or near the water main where a new water connection is desired. From this test hydrant, a static pressure and a residual pressure will be measured.
A water tunnel is an experimental facility used for testing the hydrodynamic behavior of submerged bodies in flowing water. It functions similar to a recirculating wind tunnel , but uses water as the working fluid, and related phenomena are investigated, such as measuring the forces on scale models of submarines or lift and drag on hydrofoils .
Traction can also refer to the maximum tractive force between a body and a surface, as limited by available friction; when this is the case, traction is often expressed as the ratio of the maximum tractive force to the normal force and is termed the coefficient of traction (similar to coefficient of friction).
This characteristic allows fluids to transmit force through the length of pipes or tubes; i.e., a force applied to a fluid in a pipe is transmitted, via the fluid, to the other end of the pipe. This principle was first formulated, in a slightly extended form, by Blaise Pascal, and is now called Pascal's law. [citation needed]
The low-end test equipment is dominated by few large suppliers, notably Germany's Loviband and Merck, DelAgua & ITS Europe Water Testing of the UK who work globally, and US-based LaMotte. Major manufacturers of in-line equipment include Siemens and Danaher's Hach. Thermo Scientific and Waters are key producers of high-end test equipment. [38]
Bollard pull is a conventional measure of the pulling (or towing) power of a watercraft.It is defined as the force (usually in tonnes-force or kilonewtons (kN)) exerted by a vessel under full power, on a shore-mounted bollard through a tow-line, commonly measured in a practical test (but sometimes simulated) under test conditions that include calm water, no tide, level trim, and sufficient ...
Stress has dimension of force per area, with SI units of newtons per square meter (N/m 2) or pascal (Pa). [1] Stress expresses the internal forces that neighbouring particles of a continuous material exert on each other, while strain is the measure of the relative deformation of the material. [3]
A rotameter consists of a tapered tube, typically made of glass with a 'float' (a shaped weight, made either of anodized aluminum or a ceramic), inside that is pushed up by the drag force of the flow and pulled down by gravity. The drag force for a given fluid and float cross section is a function of flow speed squared only, see drag equation. [3]