enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Wire gauge - Wikipedia

    en.wikipedia.org/wiki/Wire_gauge

    Wire gauge is a measurement of wire diameter. ... is 0.50 inches (500 mils or 12.7 mm) in diameter (250 000 circular mils in cross-sectional area), and the smallest ...

  3. American wire gauge - Wikipedia

    en.wikipedia.org/wiki/American_wire_gauge

    By definition, 36 AWG is 0.005 inches in diameter, and 0000 AWG is 0.46 inches in diameter. The ratio of these diameters is 1:92, and there are 40 gauge sizes from 36 to 0000, or 39 steps. Because each successive gauge number increases cross sectional area by a constant multiple, diameters vary geometrically.

  4. Millimetre - Wikipedia

    en.wikipedia.org/wiki/Millimetre

    Different lengths as in respect to the electromagnetic spectrum, measured by the metre and its derived scales.The microwave is between 1 meter to 1 millimeter.. The millimetre (international spelling; SI unit symbol mm) or millimeter (American spelling) is a unit of length in the International System of Units (SI), equal to one thousandth of a metre, which is the SI base unit of length.

  5. Standard wire gauge - Wikipedia

    en.wikipedia.org/wiki/Standard_wire_gauge

    A table of the gauge numbers and wire diameters is shown below. [1] [2] The basis of the system is the thou (or mil in US English), or 0.001 in. Sizes are specified as wire diameters, stated in thou and tenths of a thou (mils and tenths). The wire diameter diminishes with increasing size number.

  6. Circular mil - Wikipedia

    en.wikipedia.org/wiki/Circular_mil

    A circular mil is a unit of area, equal to the area of a circle with a diameter of one mil (one thousandth of an inch or 0.0254 mm). It is equal to π /4 square mils or approximately 5.067 × 10 −4 mm 2 .

  7. File:Mm to 1 inch fraction ruler.svg - Wikipedia

    en.wikipedia.org/wiki/File:Mm_to_1_inch_fraction...

    English: a ruler from 0 to 1 inch (in.) in 1/32 inch divisions below the line and 1/2 millimetre (mm) divisions above the line to give a visual representation of the approximations. Principally designed to help visually determine if a metric or imperial drill bit will suffice.

  8. Wire - Wikipedia

    en.wikipedia.org/wiki/Wire

    The conductor consists of seven strands of steel (centre, high tensile strength), surrounded by four outer layers of aluminium (high conductivity). Sample diameter 40 mm. A wire is a flexible, round bar of metal. Wires are commonly formed by drawing the metal through a hole in a die or draw plate.

  9. Ohm - Wikipedia

    en.wikipedia.org/wiki/Ohm

    Iron wire 1 km long and 4 mm 2 cross section Matthiessen 13.59 1 mi (1.609 km) of 1 ⁄ 16-inch-diameter (1.588 mm) pure annealed copper wire at 15.5 °C Varley 25.61 One mile of special 1 ⁄ 16-inch-diameter copper wire German mile 57.44 A German mile (8,238 yd or 7,533 m) of iron wire 1 ⁄ 6 in (4.233 mm) diameter Abohm: 10 −9