Search results
Results from the WOW.Com Content Network
High radon levels in a Minnesota (USA) basement with a passive under slab vent pipe system can be seen in the left half of the graph. After installation of a radon fan (ASD), a permanent reduction in radon levels to approximately 0.6 pCi/L can be seen in the right half of the graph. The most common approach is active soil depressurization (ASD).
Jan. 18—ATHENS — January is National Radon Action month, and each year University of Georgia Cooperative Extension sponsors a poster contest for students across the state to help bring ...
Radon is measured in picocuries per liter of air (pCi/L) or becquerel per cubic meter (Bq m-3). Both are measurements of radioactivity. The World Health Organization (WHO) sets the ideal indoor radon levels at 100 Bq/m-3. [97] In the United States, it is recommend to fix homes with radon levels at or above 4 pCi/L.
Very high radon concentrations (>1000 Bq/m 3) have been found in houses built on soils with a high uranium content and/or high permeability of the ground. If levels are 20 picocuries radon per liter of air (800 Bq/m 3 ) or higher, the home owner should consider some type of procedure to decrease indoor radon levels.
Lighter Side. Medicare
Radon levels in homes can be reduced by: * increasing under-floor ventilation; * installing a radon sump system in the basement or under a solid floor; * avoiding the passage of radon from the basement into living rooms; * sealing floors and walls; and * improving the ventilation of the house .
A slab-on-grade or basement floor should be poured over a cross-laminated polyethylene vapor barrier over 4 inches (10 cm) of granular fill to prevent wicking of moisture from the ground and radon gas incursion. Inside a steel building, water vapor will condense whenever it comes into contact with a surface that is below the dew point temperature.
In a working mine, the radon level can be controlled by ventilation, sealing off old workings and controlling the water in the mine. The level in a mine can go up when a mine is abandoned; it can reach a level which can cause the skin to become red (a mild radiation burn). The radon levels in some of the mines can reach 400 to 700 kBq m −3. [17]