enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Strapping - Wikipedia

   en.wikipedia.org/wiki/Strapping

   Steel is the oldest and highest tensile strength strapping. It is available in a variety of widths and thicknesses as well as variations in the grade of steel. Steel is used for heavy duty holding where high strength and minimal stretch are desired. Surface finishes for steel strap include: paint, paint and wax, bluing, or zinc and wax.

3. End-face mechanical seal - Wikipedia

   en.wikipedia.org/wiki/End-face_mechanical_seal

   Carbon-graphite was widely used as a seal face material; the mating seal face was often cast iron, Ni-resist, 400 series stainless steel, Stellite or aluminum oxide although tungsten carbide was coming into use. Stainless steel was widely used for springs, retainers, sleeves and glands.

4. Garter spring - Wikipedia

   en.wikipedia.org/wiki/Garter_spring

   A garter spring inside a rubber seal. A garter spring is a coiled steel spring that is connected at each end to create a circular shape, and is used in oil seals, shaft seals, belt-driven motors, and electrical connectors. Compression garter springs exert outward radial forces, while extension garter springs exert inward radial forces.

5. Hermetic seal - Wikipedia

   en.wikipedia.org/wiki/Hermetic_seal

   Hermetic epoxy seals also offer the design flexibility of sealing either copper alloy wires or pins instead of the much less electrically conductive Kovar pin materials required in glass or ceramic hermetic seals. With a typical operating temperature range of −70 °C to +125 °C or 150 °C, epoxy hermetic seals are more limited in comparison ...

6. Gasket - Wikipedia

   en.wikipedia.org/wiki/Gasket

   Internal pressure acts upon the faces of the V, forcing the gasket to seal against the flange faces. Most spiral wound gasket applications will use two standard gasket thicknesses: 1/8 inch and 3/16 inch. With 1/8 inch thick gaskets, compression to a 0.100 inch thickness is recommended. For 3/16 inches, compress to a 0.13 inch thickness.

7. API Standard 682 - Wikipedia

   en.wikipedia.org/wiki/API_Standard_682

   Category 2 seal are intended for API-610 This category is applicable for temperatures between –40 °F and 750 °F (-40 °C and 400 °C) and pressures to 615 PSI (42 bar). Category 3 seals are essentially the original seals of 1st Edition and are also intended for API-610 pumps. Category 3 seals are intended for the most demanding applications.