Search results
Results from the WOW.Com Content Network
The most common usage is the DB25, using TASCAM's pinout (now standardised in AES59 by the Audio Engineering Society [1]). To avoid the possibility of bent pins on fixed equipment, the male connector is generally fitted to the cabling and the female connector to the equipment.
This file is licensed under the Creative Commons Attribution-Share Alike 3.0 Unported, 2.5 Generic, 2.0 Generic and 1.0 Generic license. You are free: to share – to copy, distribute and transmit the work
For example, DB-25 denotes a D-sub with a 25-position shell size and a 25-position contact configuration. The contacts in each row of these connectors are spaced 326/3000 of an inch apart, or approximately 0.1087 inches (2.76 mm), and the rows are spaced 0.112 inches (2.84 mm) apart; the pins in the two rows are offset by half the distance ...
Male pinout of a 25-pin serial port (D-subminiature, DB-25) commonly found on 1980s computers. The following table lists commonly used RS-232 signals (called "circuits" in the specifications) and their pin assignments on the recommended DB-25 connectors [14] (see Serial port pinouts for other commonly used connectors not defined by the standard).
So to send the digit 9, pins 14 (1) and 17 (8) would be put to the "mark" state, whereas the digit 6 would mark pins 15 and 16. With each digit, the host system data terminal equipment (DTE, typically a computer) would raise pin 2 to indicate the digit was ready for the dialler to read. When the dialler completed the read, it would raise pin 5 ...
Pin No (DB25) Pin No (36 pin) Signal name Direction Register - bit Inverted 1 1 Strobe In/out Control-0 Yes 2 2 Data0 Out Data-0 No 3 3 Data1 Out Data-1 No 4 4 Data2 Out Data-2 No 5 5 Data3 Out Data-3 No 6 6 Data4 Out Data-4 No 7 7 Data5 Out Data-5 No 8 8 Data6 Out Data-6 No 9 9 Data7 Out Data-7 No 10 10 Ack In Status-6 No 11 11 Busy In Status-7
Jason Day hits out of a green-side bunker on the 8th hole during the first round of the U.S. Open at Los Angeles Country Club. Pin placement green approaches.
The power connector was typically the same 4-pin female Molex connector used in many other internal computer devices. The communication connectors on the drives were usually a 50 (for 8-bit SCSI) or 68 pin male (for 16-bit SCSI) "IDC header" which has two rows of pins, 0.1 inches apart.