Search results
Results from the WOW.Com Content Network
The goal of EGR is thus to reduce NO x production by reducing the combustion temperatures. In modern diesel engines, the EGR gas is usually cooled with a heat exchanger to allow the introduction of a greater mass of recirculated gas. However, uncooled EGR designs do exist; these are often referred to as hot-gas recirculation (HGR).
BMW recalled certain 2023-2024 X1, X5, X6, X7, XM, 530i, i5, 740i, 760i, i7, and 750e vehicles.. The NHTSA report said that the integrated brake system may malfunction and result in a loss of ...
Water Injection and cooled exhaust gas recirculation (EGR) could be seen as competitive technologies: it has been demonstrated that at medium load a 40-50 % Water-to-Fuel Ratio (WFR) with Port Water Injection (PWI) has the same effect as an EGR-rate of 10%, which is seen as relatively limited even for petrol engines. [15]
Three unique models that BMW Motorsport created for the South African market were the E23 M745i (1983), which used the M88 engine from the BMW M1, the BMW 333i (1986), which added a six-cylinder 3.2-litre M30 engine to the E30, [133] and the E30 BMW 325is (1989) which was powered by an Alpina-derived 2.7-litre engine.
The AOL.com video experience serves up the best video content from AOL and around the web, curating informative and entertaining snackable videos.
This causes excessive buildup in the cooler matrix, and when the engine warms up these solid chunks of buildup can detach from the EGR cooler and get sucked into the plastic intake tube, melting holes in the intake tube, causing a massive boost leak and in very rare cases an engine fire. BMW has issued a recall to over 1.6 million vehicles in ...
A growing body of evidence has shown links between cancer and drinking alcohol. In a warning Friday, U.S. Surgeon General Vivek Murthy said cancer risk increases with the number of drinks, but ...
Diesel engines are typically well suited to turbocharging due to two factors: A "lean" air–fuel ratio, caused when the turbocharger supplies excess air into the engine, is not a problem for diesel engines, because the torque control is dependent on the mass of fuel that is injected into the combustion chamber (i.e. air-fuel ratio), rather than the quantity of the air-fuel mixture.