Search results
Results from the WOW.Com Content Network
For example, if the static compression ratio is 10:1, and the dynamic compression ratio is 7.5:1, a useful value for cylinder pressure would be 7.5 1.3 × atmospheric pressure, or 13.7 bar (relative to atmospheric pressure). The two corrections for dynamic compression ratio affect cylinder pressure in opposite directions, but not in equal strength.
Over 500 vehicles were converted to high compression and dedicated use of the 85/15 methanol and ethanol. In 1982 the big three were each given $5,000,000 for design and contracts for 5,000 vehicles to be bought by the State. It was an early use of low-compression flexible-fuel vehicles.
In naturally aspirated engines powered by octane, maximum power is frequently reached at AFRs ranging from 12.5 to 13.3:1 or λ of 0.850 to 0.901. [citation needed] The air-fuel ratio of 12:1 is considered as the maximum output ratio, whereas the air-fuel ratio of 16:1 is considered as the maximum fuel economy ratio. [citation needed]
Stratified charge compression ignition also relies on temperature and density increase resulting from compression. However, it injects fuel later, during the compression stroke. Combustion occurs at the boundary of the fuel and air, producing higher emissions, but allowing a leaner and higher compression burn, producing greater efficiency.
3LR12 (4.5-volt), D, C, AA, AAA, AAAA (1.5-volt), A23 (12-volt), PP3 (9-volt), CR2032 (3-volt), and LR44 (1.5-volt) batteries (Matchstick for reference). This is a list of the sizes, shapes, and general characteristics of some common primary and secondary battery types in household, automotive and light industrial use.
A common coaxial power connector, male (left) and female (right), 5.5 × 2.5 mm. Connector gender is determined by the center contact. Note: connectors depicted do not connect with each other.
Four-stroke cycle used in gasoline/petrol engines: intake (1), compression (2), power (3), and exhaust (4). The right blue side is the intake port and the left brown side is the exhaust port. The cylinder wall is a thin sleeve surrounding the piston head which creates a space for the combustion of fuel and the genesis of mechanical energy.
The three-cylinder 1.0-litre version of K engine, fitted in many Suzuki's city cars since 2008. In 2014, this engine was reworked by increasing the compression ratio from 10.0 to 11.0:1 and known as K-Next. This changes claimed to increase the petrol mileage over 23km/L, achieved maximum power on lower rev and reduced frictional losses. [9]