Search results
Results from the WOW.Com Content Network
GSM module or GPRS modules are similar to modems, but there's one difference: the modem is an external piece of equipment, whereas the GSM module or GPRS module can be integrated within an electrical or electronic equipment. It is an embedded piece of hardware. A GSM mobile, on the other hand, is a complete embedded system in itself.
Enhanced Data Rates for GSM Evolution (EDGE) (E-GPRS) and Universal Mobile Telecommunications System (UMTS) provide improved radio interfaces with higher data rates, while still being backward compatible with the GSM core network. Enhanced Circuit Switched Data (ECSD) was developed alongside GPRS/EDGE [2]
GPRS Tunnelling Protocol is the defining IP-based protocol of the GPRS core network. Primarily it is the protocol which allows end users of a GSM or WCDMA network to move from place to place while continuing to connect to the Internet as if from one location at the Gateway GPRS support node (GGSN).
This is used in GSM to separate cells, which then use TDMA to separate users within the cell. Code-division multiple access (CDMA) This uses a digital modulation called spread spectrum which spreads the voice data over a very wide channel in pseudorandom fashion using a user or cell specific pseudorandom code. The receiver undoes the ...
The GSM standard originally described a digital, circuit-switched network optimized for full duplex voice telephony. This expanded over time to include data communications, first by circuit-switched transport, then by packet data transport via General Packet Radio Service (GPRS), and Enhanced Data Rates for GSM Evolution (EDGE).
The General Packet Radio Service (GPRS) is a packet-switched data transmission protocol, which was incorporated into the GSM standard in 1997. It is backwards-compatible with systems that use pre-1997 versions of the standard.
The HLR data is stored for as long as a subscriber remains with the mobile phone operator. Examples of other data stored in the HLR against an IMSI record is: GSM services that the subscriber has requested or been given. General Packet Radio Service (GPRS) settings to allow the subscriber to access packet services.
Typical 2G standards include GSM and IS-95 with extensions via GPRS, EDGE and 1xRTT, providing Internet access to users of originally voice centric 2G networks. Both EDGE and 1xRTT are 3G standards, as defined by the ITU , but are usually marketed as 2.9G due to their comparatively low speeds and high delays when compared to true 3G technologies.