Search results
Results from the WOW.Com Content Network
A data cable (top) and control cable (below) connecting a controller card and an ST-506 type HDD. Power cable not shown. The earliest hard disk drive (HDD) interfaces were bit serial data interfaces that connected an HDD to a controller with two cables, one for control and one for data.
A SCSI connector (/ ˈ s k ʌ z i / SKUZ-ee) is used to connect computer parts that communicate with each other via the SCSI standard. Generally, two connectors, designated male and female, plug together to form a connection which allows two components, such as a computer and a disk drive, to communicate with each other.
Seagate ST11R, an 8-bit ISA RLL hard disk controller produced in 1990. A disk controller is a controller circuit that enables a CPU to communicate with a hard disk, floppy disk or other kind of disk drive. It also provides an interface between the disk drive and the bus connecting it to the rest of the system. [1] [2]
In computing, Serial Attached SCSI (SAS) is a point-to-point serial protocol that moves data to and from computer-storage devices such as hard disk drives, solid-state drives and tape drives. SAS replaces the older Parallel SCSI (Parallel Small Computer System Interface, usually pronounced "scuzzy" [ 3 ] [ 4 ] ) bus technology that first ...
Direct memory access (DMA) is a feature of computer systems that allows certain hardware subsystems to access main system memory independently of the central processing unit (CPU). [ 1 ] Without DMA, when the CPU is using programmed input/output , it is typically fully occupied for the entire duration of the read or write operation, and is thus ...
Small Computer System Interface (SCSI, / ˈ s k ʌ z i / SKUZ-ee) [2] is a set of standards for physically connecting and transferring data between computers and peripheral devices, best known for its use with storage devices such as hard disk drives.
At Intel, the authors of the PCI specification viewed the PCI local bus as being at the very centre of the PC platform architecture (i.e., at the Equator). The northbridge extends to the north of the PCI bus backbone in support of CPU, memory/cache, and other performance-critical capabilities. Likewise the southbridge extends to the south of ...
If the boot order is set to "first, the DVD drive; second, the hard disk drive", then the firmware will try to boot from the DVD drive, and if this fails (e.g. because there is no DVD in the drive), it will try to boot from the local hard disk drive. For example, on a PC with Windows installed on the hard drive, the user could set the boot ...