enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Beam (nautical) - Wikipedia

    en.wikipedia.org/wiki/Beam_(nautical)

    Graphical representation of the dimensions used to describe a ship. Dimension "b" is the beam at waterline.. The beam of a ship is its width at its widest point. The maximum beam (B MAX) is the distance between planes passing through the outer sides of the ship, beam of the hull (B H) only includes permanently fixed parts of the hull, and beam at waterline (B WL) is the maximum width where the ...

  3. Ship measurements - Wikipedia

    en.wikipedia.org/wiki/Ship_measurements

    Beam – A measure of the width of the ship. There are two types: Beam, Overall (BOA), commonly referred to simply as Beam – The overall width of the ship measured at the widest point of the nominal waterline. Beam on Centerline (BOC) – Used for multihull vessels. The BOC for vessels is measured as follows: For a catamaran: the ...

  4. Glossary of nautical terms (A–L) - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_nautical_terms...

    abaft the beam Farther aft than the beam ; a relative bearing of greater than 90 degrees from the bow ; e.g. "two points abaft the beam, starboard side" would describe "an object lying 22.5 degrees toward the rear of the ship, as measured clockwise from a perpendicular line from the right side, center, of the ship, toward the horizon".

  5. Point of sail - Wikipedia

    en.wikipedia.org/wiki/Point_of_sail

    A beam reach is when the true wind is at a right angle to the direction of motion (so called because the wind is parallel to the cross-hull beams, if any; see beam). A broad reach is when the wind is coming from behind the sailing craft at an angle. This represents a range of wind angles, between a beam reach (see next paragraph) and running ...

  6. Hogging and sagging - Wikipedia

    en.wikipedia.org/wiki/Hogging_and_sagging

    Hogging is the stress a ship's hull or keel experiences that causes the center or the keel to bend upward. Sagging is the stress a ship's hull or keel is placed under when a wave is the same length as the ship and the ship is in the trough of two waves.

  7. Hull (watercraft) - Wikipedia

    en.wikipedia.org/wiki/Hull_(watercraft)

    Midship coefficient (C m or C x) is the cross-sectional area (A x) of the slice at midships (or at the largest section for C x) divided by beam x draft. It displays the ratio of the largest underwater section of the hull to a rectangle of the same overall width and depth as the underwater section of the hull.

  8. Glossary of nautical terms - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_nautical_terms

    Glossary of nautical terms may refer to: Glossary of nautical terms (A–L) Glossary of nautical terms (M–Z) This page was last edited on 25 ...

  9. List of ship directions - Wikipedia

    en.wikipedia.org/wiki/List_of_ship_directions

    Abaft (preposition): at or toward the stern of a ship, or further back from a location, e.g. "the mizzenmast is abaft the mainmast". [1]Aboard: onto or within a ship, or in a group.