Search results
Results from the WOW.Com Content Network
Bobbin lace requires the winding of yarn onto a temporary storage spindle made of wood (or, in earlier times, bone) often turned on a lathe. Many lace designs require dozens of bobbins at any one time. Both traditional and contemporary bobbins may be decorated with designs, inscriptions, or pewter or wire inlays.
A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube (designated by actual size, with lower tolerance for variance), adapt to different sizes or shapes, and for other purposes such as regulating (or measuring) fluid flow.
Keeping the air flowing correctly through a wood-burning stove is essential for safe and efficient operation of the stove. Fresh air needs to enter the firebox to provide oxygen for the fire; as the fire burns, the smoke must be allowed to rise through the stove pipe, creating negative pressure in the firebox, and exit through the chimney.
A turnbuckle, stretching screw or bottlescrew is a device for adjusting the tension or length of ropes, cables, tie rods, and other tensioning systems. It normally consists of two threaded eye bolts , one screwed into each end of a small metal frame, one with a conventional right-hand thread and the other with a left-hand thread.
A spring pin (also called tension pin or roll pin) is a mechanical fastener that secures the position of two or more parts of a machine relative to each other. Spring pins have a body diameter which is larger than the diameter of the hole they are intended for, and a chamfer on either one or both ends to facilitate starting the pin into the hole.
Alternatively, split cable entry systems can be used (normally consisting of a hard frame and several sealing grommets) to route a large number of pre-terminated cables through one wall cut-out. There are at least three types of thread standards used: Panzergewinde (PG standard) Metric thread; National Pipe Thread (inch system)
Wood stave pipeline part of the Yakima Project. A stave is a narrow length of wood with a slightly bevelled edge to form the sides of barrels, tanks, tubs, vats and pipelines, originally handmade by coopers. [1] They have been used in the construction of large holding tanks and penstocks at hydro power developments. [2]
Narrow gauge flat wagons, 750 mm (2 ft 5 + 1 ⁄ 2 in).Note the single buffer with a hook on the right side and a chain on the other. On some narrow-gauge lines in Europe, and on the Paris Metro, a simplified version of the loose-coupler is used, consisting of a single central buffer with a chain underneath.