enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Copper tubing - Wikipedia

   en.wikipedia.org/wiki/Copper_tubing

   Solder fittings are smooth and easily slip onto the end of a tubing section. The joint is then heated using a torch, and the solder is melted into the connection. When the solder cools, it forms a very strong bond that can last for decades. Solder-connected rigid copper is the most popular choice for water supply lines in modern buildings.

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   The bodies of fittings for pipe and tubing are often the same base material as the pipe or tubing connected: copper, steel, PVC, CPVC, or ABS. Any material permitted by the plumbing, health, or building code (as applicable) may be used, but it must be compatible with the other materials in the system, the fluids being transported, and the ...

4. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

5. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   Flared fittings are an alternative to solder-type joints that are mechanically separable and doesn’t require an open flame. Copper tube used for propane, liquefied petroleum gas, or natural gas may use flared brass fittings of single 45°-flare type, according to NFPA 54/ANSI. Z223.1 National Fuel Gas Code.

6. Push-to-pull compression fittings - Wikipedia

   en.wikipedia.org/wiki/Push-to-pull_compression...

   Pipes are often marked to show the insertion depth, so if you cut at a mark, then insert the pipe up to the next mark, you will have a good connection. Hepworth pipe has always had this feature, for example. Making a mark before insertion is advised on pipe that is not pre-marked (e.g. copper pipe). Hepworth supply an insert with bulges on the end.

7. Pipe (fluid conveyance) - Wikipedia

   en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

   The history of copper pipe is similar. In the 1930s, the pipe was designated by its internal diameter and a 1 ⁄ 16-inch (1.6 mm) wall thickness. Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings.