Search results
Results from the WOW.Com Content Network
A slider-crank linkage is a four-bar linkage with three revolute joints and one prismatic, or sliding, joint. The rotation of the crank drives the linear movement the slider, or the expansion of gases against a sliding piston in a cylinder can drive the rotation of the crank. There are two types of slider-cranks: in-line and offset. In-line
Watt's linkage consists of three bars bolted together in a chain. The chain of bars consists of two end bars and a middle bar. The middle bar is bolted at each of its ends to one of the ends of each outer bar. The two outer bars are of equal length, and are longer than the middle bar. The three bars can pivot around the two bolts.
A four-bar linkage can be constructed from any point on the two perpendicular bisectors as the fixed pivots and A and B as the moving pivots. The point P is clearly special, because it is a hinge that allows pure rotational movement of A 1 B 1 to A 2 B 2. It is called the relative displacement pole or also instant centre of rotation.
N = 2, j = 1: this is a two-bar linkage known as the lever; N = 4, j = 4: this is the four-bar linkage; N = 6, j = 7: this is a six-bar linkage [ it has two links that have three joints, called ternary links, and there are two topologies of this linkage depending how these links are connected. In the Watt topology, the two ternary links are ...
Watt's parallel motion on a pumping engine. In previous engines built by Newcomen and Watt, the piston pulled one end of the walking beam downwards during the power stroke using a chain, and the weight of the pump pulled the other end of the beam downwards during the recovery stroke using a second chain, the alternating forces producing the rocking motion of the beam.
To direct water to many users, municipal water supplies often route it through a water supply network. A major part of this network will consist of interconnected pipes. This network creates a special class of problems in hydraulic design, with solution methods typically referred to as pipe network analysis. Water utilities generally make use ...
The exception in this list is Watt's parallel motion, which combines Watt's linkage with another four-bar linkage – the pantograph – to amplify the existing approximate straight line movement. It is not possible to create perfectly straight line motion using a four-bar linkage, without using a prismatic joint. Watt's linkage (1784)
These links are usually oriented 180 degrees of each other, so when pairing, these links can be fused. This creates a 4-bar linkage with two additional links, both of which are defined by the original four-bar linkage. The former ground link of the fusing 4-bar linkage becomes a rectilinear link that travels follows the same coupler curve.