Search results
Results from the WOW.Com Content Network
Water table (architecture) A water table is a projection of lower masonry on the outside of a wall, slightly above the ground, or at the top of a wainscot section of a wall (in this case also known as a sill). It is both a functional and architectural feature that consists of a projection that deflects water running down the face of a building ...
In engineering, a foundation is the element of a structure which connects it to the ground or more rarely, water (as with floating structures), transferring loads from the structure to the ground. Foundations are generally considered either shallow or deep. [ 1 ] Foundation engineering is the application of soil mechanics and rock mechanics ...
Timber sills can span gaps in a foundation. A sill plate or sole plate in construction and architecture is the bottom horizontal member of a wall or building to which vertical members are attached. The word "plate" is typically omitted in America and carpenters speak simply of the "sill". Other names are rat sill, ground plate, ground sill ...
A basement wall is thus one kind of retaining wall; however, the term usually refers to a cantilever retaining wall, which is a freestanding structure without lateral support at its top. [2] These are cantilevered from a footing and rise above the grade on one side to retain a higher level grade on the opposite side.
An example of lateral earth pressure overturning a retaining wall. The lateral earth pressure is the pressure that soil exerts in the horizontal direction. It is important because it affects the consolidation behavior and strength of the soil and because it is considered in the design of geotechnical engineering structures such as retaining walls, basements, tunnels, deep foundations and ...
A moat was a common addition to medieval fortifications, and the principal purpose was to simply increase the effective height of the walls and to prevent digging under the walls. In many instances, natural water paths were used as moats, and often extended through ditches to surround as much of the fortification as possible.
The "height stones" refer to two stones that indicate height: during the first phase of construction a stone with an inscription that includes the phrase "from the foundation to this height 100 feet" (30 m) was installed just below the 80–90-foot (24–27 m) stairway and high above the 60–70-foot (18–21 m) stairway; [9]: sheet 25 [47]: 52 ...
The batter angle is typically described as a ratio of the offset and height or a degree angle that is dependent on the building materials and application. For example, typical dry-stone construction of retaining walls utilizes a 1:6 ratio, that is for every 1 inch that the wall steps back, it increases 6 inches in height. [5]