Search results
Results from the WOW.Com Content Network
The Federal Bridge Gross Weight Formula, also known as Bridge Formula B or the Federal Bridge Formula, is a mathematical formula in use in the United States by truck drivers and Department of Transportation (DOT) officials to determine the appropriate maximum gross weight for a commercial motor vehicle (CMV) based on axle number and spacing.
The American Association of State Highway and Transportation Officials (AASHTO) is a standards setting body which publishes specifications, test protocols, and guidelines that are used in highway design and construction throughout the United States. Despite its name, the association represents not only highways but air, rail, water, and public ...
Standards for Interstate Highways in the United States are defined by the American Association of State Highway and Transportation Officials (AASHTO) in the publication A Policy on Design Standards: Interstate System. For a certain highway to be considered an Interstate Highway, it must meet these construction requirements or obtain a waiver ...
The AASHO road test introduced many concepts in pavement engineering, including the load equivalency factor. Unsurprisingly, the heavier vehicles reduced the serviceability in a much shorter time than light vehicles, and the oft-quoted figure, called the generalized fourth power law , [ 3 ] that damage caused by vehicles is "related to the 4th ...
In civil engineering, clearance refers to the difference between the loading gauge and the structure gauge in the case of railroad cars or trams, or the difference between the size of any vehicle and the width/height of doors, the width/height of an overpass or the diameter of a tunnel as well as the air draft under a bridge, the width of a lock or diameter of a tunnel in the case of watercraft.
The AASHTO Soil Classification System was developed by the American Association of State Highway and Transportation Officials, and is used as a guide for the classification of soils and soil-aggregate mixtures for highway construction purposes. The classification system was first developed by Hogentogler and Terzaghi in 1929, [1] but has been ...
When light-duty trucks were first produced in the United States, they were rated by their payload capacity in tons: 1 ⁄ 2 (1000 pounds), 3 ⁄ 4 (1500 pounds) and 1-ton (2000 pounds). Ford had introduced the "One-Tonner" in 1938 to their line of trucks. [22] The "Three-quarter-tonner" appeared in the Ford truck lineup in 1939. [22]
The primary US guidance is found in A Policy on Geometric Design of Highways and Streets published by the American Association of State Highway and Transportation Officials (AASHTO). [2] Other standards include the Australian Guide to Road Design Archived 2011-11-09 at the Wayback Machine, and the British Design Manual for Roads.