enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Turnbuckle - Wikipedia

   en.wikipedia.org/wiki/Turnbuckle

   A turnbuckle, stretching screw or bottlescrew is a device for adjusting the tension or length of ropes, cables, tie rods, and other tensioning systems. It normally consists of two threaded eye bolts , one screwed into each end of a small metal frame, one with a conventional right-hand thread and the other with a left-hand thread.

3. Rod end bearing - Wikipedia

   en.wikipedia.org/wiki/Rod_end_bearing

   A rod end bearing, also known as a heim joint (North America) or rose joint (UK and elsewhere), is a mechanical articulating joint. Such joints are used on the ends of control rods, steering links , tie rods , or anywhere a precision articulating joint is required, and where a clevis end (which requires perfect alignment between the components ...

4. D-ring - Wikipedia

   en.wikipedia.org/wiki/D-ring

   D-rings are attached to the tops or bottoms of flats with a "drift line" and turnbuckle attached to adjust the "trim". A D-ring on an M16 or variant type rifle is used to increase the pressure on the extractor and reduce malfunctions. This D-ring is a rubber grommet shaped like a "D" and fits over the extractor spring adding tension to it.

5. Automatic center punch - Wikipedia

   en.wikipedia.org/wiki/Automatic_center_punch

   (The spring's preload compression can usually be adjusted by loosening or tightening the end cap at the back-most portion of the punch, to decrease or increase the force of the punch.) A stopped hole drilled in the front center portion of the hammer mass facing the tumbler acts as a receiver for the rod, and as an anvil for the punch action.

6. Crankshaft - Wikipedia

   en.wikipedia.org/wiki/Crankshaft

   The crankshaft is a rotating shaft containing one or more crankpins, [1] that are driven by the pistons via the connecting rods. [2] The crankpins are also called rod bearing journals, and they rotate within the "big end" of the connecting rods. Most modern crankshafts are located in the engine block.

7. Rigging (material handling) - Wikipedia

   en.wikipedia.org/wiki/Rigging_(material_handling)

   Rigging is the equipment such as wire rope, turnbuckles, clevis, jacks used with cranes and other lifting equipment [1] in material handling and structure relocation. Rigging systems commonly include shackles , master links and slings , and lifting bags in underwater lifting.