enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Street elbow - Wikipedia

   en.wikipedia.org/wiki/Street_elbow

   Street elbows are available with bend angles of 90°, 45°, and 22.5°. They can be used in many plumbing applications, including water supply, drainage, sewers, vents, central vacuum systems, compressed air and gas lines, heating and air conditioning, sump pump drains, and other locations where plumbing fittings would be used to join sections of pipe.

3. JIC fitting - Wikipedia

   en.wikipedia.org/wiki/JIC_fitting

   JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.

4. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   In plumbing, the term "45-degree elbow" for example, refers to the angle of bend from the original straight pipe position (0 degrees) to the new position (45 degrees), not the actual angle formed by the joint. On a protractor, the actual angle of the above joint is 135 degrees, an obtuse angle.

5. Compression fitting - Wikipedia

   en.wikipedia.org/wiki/Compression_fitting

   A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect

6. Trainers Always Start A Workout With One Of These ... - AOL

   www.aol.com/trainers-never-start-workout-without...

   Start standing with feet shoulder-width apart and elbows bent at a 90-degree angle. Lift your right leg and bend the knee, circling it in, up, and around. Place your right foot back in the same spot.

7. Flare fitting - Wikipedia

   en.wikipedia.org/wiki/Flare_fitting

   Flared fittings are an alternative to solder-type joints that are mechanically separable and doesn’t require an open flame. Copper tube used for propane, liquefied petroleum gas, or natural gas may use flared brass fittings of single 45°-flare type, according to NFPA 54/ANSI. Z223.1 National Fuel Gas Code.