enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wiring Harness Manufacturer's Association - Wikipedia

   en.wikipedia.org/wiki/Wiring_Harness_Manufacturer...

   The Wiring Harness Manufacturer's Association is a trade group for American manufacturers of wiring harnesses, electronic cable assemblies, and cord sets, along with their suppliers and distributors. [1] It publishes the widely used standard IPC/WHMA-A-620 Acceptability of Electronic Wire Harnesses and Cables jointly with IPC. [2]

3. IPC (electronics) - Wikipedia

   en.wikipedia.org/wiki/IPC_(electronics)

   IPC is a trade association whose aim is to standardize the assembly and production requirements of electronic equipment and assemblies. IPC is headquartered in Bannockburn, Illinois, United States with additional offices in Washington, D.C. Atlanta, Ga., and Miami, Fla. in the United States, and overseas offices in China, Japan, Thailand, India, Germany, and Belgium.

4. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45) A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35. Connectors on this cable would be designated:

5. Cable harness - Wikipedia

   en.wikipedia.org/wiki/Cable_harness

   The IPC/WHMA-A-620 publication has standards for a wide range of elements within a cable harness, including but not limited to electrostatic discharge protection, conduit, installation and repairs, crimping, pull-test requirements, and other operations that are critical to the production and function of cable harnesses. [12] The standards ...

6. Hermes protocol - Wikipedia

   en.wikipedia.org/wiki/Hermes_protocol

   Hermes is a machine-to-machine communication standard used in the SMT assembly industry. [1]IPC-HERMES-9852. It is a successor to the SMEMA standard, introducing improvements such as: simpler physical wiring (Ethernet), use of popular data transmission formats (TCP/IP and XML), reduced number of barcode scanners (required only once at the beginning of the line), transmission of board data ...

7. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.