enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Rack and pinion - Wikipedia

   en.wikipedia.org/wiki/Rack_and_pinion

   A rack and pinion has roughly the same purpose as a worm gear with a rack replacing the gear, in that both convert torque to linear force. However the rack and pinion generally provides higher linear speed — since a full turn of the pinion displaces the rack by an amount equal to the pinion's pitch circle whereas a full rotation of the worm screw only displaces the rack by one tooth width.

3. Sterling 10.5 axle - Wikipedia

   en.wikipedia.org/wiki/Sterling_10.5_axle

   The first version was produced from 1985 to 1992. The second version, produced from 1993 to 1997 featured a stronger pinion/yoke. This corrected a known, but rare, issue of the pinion yoke nut working loose. The first and second versions of the 10.25 axle are colloquially known as “short pinion-yoke” and “long pinion-yoke” respectively.

4. Hypoid gearboxes - Wikipedia

   en.wikipedia.org/wiki/Hypoid_gearboxes

   Hypoid gear sets have long been used in the differential of rear-wheel drive cars, trucks and robotic arms.The scope of misalignment between the centers of the two interlinking shafts permits utilization of larger sized gears which enhances the contact surface area and reduces the wear and tear on the gear hence extending the life and power transmission capabilities of the gearboxes.

5. Differential (mechanical device) - Wikipedia

   en.wikipedia.org/wiki/Differential_(mechanical...

   A spur-gear differential has equal-sized spur gears at each end, each of which is connected to an output shaft. [8] The input torque (i.e. from the engine or transmission) is applied to the differential via the rotating carrier. [8] Pinion pairs are located within the carrier and rotate freely on pins supported by the carrier.

6. Spiral bevel gear - Wikipedia

   en.wikipedia.org/wiki/Spiral_bevel_gear

   The shape of a hypoid gear is a revolved hyperboloid (that is, the pitch surface of the hypoid gear is a hyperbolic surface), whereas the shape of a spiral bevel gear is normally conical. The hypoid gear places the pinion off-axis to the crown wheel (ring gear) which allows the pinion to be larger in diameter and have more contact area. In ...

7. Ford MT75 transmission - Wikipedia

   en.wikipedia.org/wiki/Ford_MT75_transmission

   The MT75 replaced the Ford Type 9 transmission. The MT75 has an all alloy casing and comes with an integrated bellhousing. In 4x4 versions, the planetary gear center differential with viscous-type limited slip is integrated in to the rear half of the gearbox. The 4x4 system is of full-time type with a static torque split of 34% front, 66% rear ...